Note Using your system the receive TS440 pan

Ok Larry here is what I came up with:
Note Using your system the receive TS440 pan adapter image is very good. Almost the same as with the TS940, but on transmit
with the TS440 viewed on your unit ,there is not much visual presentation. This is a fault of where I tapped off on the TS440 and not
because of your software or hardware.
PROCEDURE:
Turn the TS440 over and remove the underside screws to acess the board. From here go to the pictures for where the top of D31 is..
It is right next to C120 cap. I used a 33uuf ceramic disc cap for the coupler. I believe any value near 33 uuf would work say 25 to
40uuf. I used mini coax to connect and grounded the shielded side to any convenient near ground point. I also added an on / off
switch and on the other end of the mini coax I added a female RCA and snaked through the back of the TS440.
That's it. Thanks Terry Clinard WA8OPR