Flip Flop Card Instructions

Transcription

Flip Flop Card Instructions
Basic Flip Flop Card Assembly
1.
Before initial use, snap off both rectangle slot dies and set aside. Run larger main die through die cutting machine
with cardstock. Place double-sided tape (Scor-Tape or red-lined tape works well) or other strong dry adhesive onto
piece as shown.
Pull off tape liners, and fold side flaps inward on score lines, starting with the right side flap and then folding in the
left side flap. When folded in, these side flaps will reinforce the flip flop mechanism.
Pre-fold on all remaining score lines of flip flop mechanism.
2.
Following instructions on the Positioning Template included with the die, place the rectangle slot dies onto the
appropriate spots of 4” x 5 1/4” cardstock, based on the flip flop panel size you want. Run through die cutting
machine. For this tutorial example, we used the LARGE die positions and white cardstock.
From the back of the white cardstock piece, insert flip flop mechanism into the upper and lower slits as shown. The
upper side flaps of the flip flop mechanism will need to be folded inward when inserting through the top slit. The
rounded end of the flip flop mechanism will be inserted through the bottom slit.
Inky Antics Rubber Stamps
3110 Payne Avenue, Cleveland, OH 44114
Phone: (800) 945-3980
Web: www.inkyantics.com
3.
Open the upper flaps of the flip flop mechanism back up again, above the top slit on the white cardstock. This is the
card front:
It should like this when viewed from the back:
Here is a side view, looking at the top edge of the card:
Phone: (800) 945-3980
4.
On the card front, fold the top piece of the mechanism downward:
It will look like this on the back:
This is the side view, from the left side edge of the card:
Phone: (800) 945-3980
5.
Here are the “open” and “closed” views of the mechanism in the card front, before attaching the flip flop panel:
Open
Closed
Pull the rounded tab downward to open the flip flop panel, and push it back upward to close the panel.
6.
To attach the flip flop panel to the card front, cut and score the appropriate size cardstock piece as listed on the
Positioning Template.
For this tutorial, we followed the LARGE instructions and scored/folded a 6” x 4 1/4” blue cardstock panel in half
to make the flip flop panel:
Phone: (800) 945-3980
7.
Place double-sided tape or dry adhesive onto flip flop panel as shown below. When placing the top edge of the blue
panel beneath the top flap of the green mechanism, make sure to center the blue panel horizontally onto the white
card. In other words, keep the same amount of white space on the left and right sides of the blue panel:
8.
Pull off tape liners, and fold up the blue panel. When the card is closed, the top flap of the green mechanism will be
covered and only the rounded pull will show at the bottom:
Phone: (800) 945-3980
9.
On the back of the white card, place double-sided tape or dry adhesive onto flip flop panel as shown below. Do not
place adhesive along the top edge of the white card; this part needs to remain unglued so allow room for the flip
flop mechanism to work properly.
10. To finish the card, layer the white card onto a 4 1/4” x 5 1/2” piece of base cardstock (which is kraft colored in this
example):
For a video tutorial of these basic assembly instructions, please visit:
http://youtu.be/gyP9cjS-B-8
Phone: (800) 945-3980
From The Whole Flock
Stamp Set & Die:
11291MC Birthday Chicks
Clear Set
IAD-012 Flip Flop Die
Cardstock:
White
5-5128 Apple Crush
7-7119 Caribbean Breeze
9-960 Kraft
Other Supplies:
Black Dye Ink Pad
Colored Pencils
Gamsol Odorless Mineral
Spirits & Blending Stumps
Ribbon Slot Punch
Green & Blue Checked
Ribbon
1. Follow instructions for Basic Flip Flop Card Assembly to make a
LARGE flip panel using Caribbean Breeze cardstock on a white
card, layered onto an Apple Crush base.
2. Stamp birthday flock image onto 2 3/4” x 4” white cardstock.
Color with pencils and blend with Gamsol.
3. Use ribbon slot punch along left edge of image piece, and thread
ribbon through slots.
4. Tie extra ribbon into bow and attach to upper left of image piece.
5. Adhere image piece to flip flop panel.
6. Stamp “Happy Birthday from the whole flock” saying onto
1 1/4” x 2 1/2” white cardstock, and layer onto 1 1/2” x 2 3/4”
Kraft cardstock.
7. Adhere layered saying piece to center of white card inside,
underneath flip flop panel.
What’s Cookin’
Stamp Set & Die:
11289SC Cooking Chicks
Clear Set
Cardstock:
White
2-235 Cherry Splash
9-960 Kraft
Other Supplies:
Black Dye Ink Pad
Colored Pencils
Phone: (800) 945-3980
Corner Rounder Punch
1. Follow instructions for Basic Flip Flop Card Assembly to make a MEDIUM
flip panel using Cherry Splash cardstock on a Kraft card, layered onto a
Cherry Splash base.
2. Trim rounded pull tab to 1/4” past score mark, if desired.
3. Stamp cooking chick image onto 2 1/4” x 2 1/2” white cardstock. Color with
pencils and blend with Gamsol.
4. Stamp “What’s cookin’ chick” saying onto 3/4” x 2 1/4” white cardstock.
5. Adhere image and saying pieces to outside of flip flop panel.
6. Stamp stacked bowls, whisk, and wooden spoon/fork images onto three 1” x
1” white cardstock pieces. Color with pencils and blend with Gamsol.
7. Use corner rounder punch on stacked bowls and wooden spoon/fork pieces
and adhere to inside of flip flop panel, as shown in sample photo.
8. Use corner rounder punch on 2 1/8” x 3 3/8” white cardstock as shown in
sample photo, and adhere to center of Kraft card inside, underneath flip flop
panel.
Which Came First
Stamp Set & Die:
11291MC Birthday Chicks
Clear Set
Cardstock:
White
4-443 Grapefruit Bliss
9-960 Kraft
1.
2.
3.
4.
5.
6.
Other Supplies:
Black Dye Ink Pad
Colored Pencils
Ribbon Slot Punch
Corner Rounder Punch
Red & White Checked
Ribbon
Follow instructions for Basic Flip Flop Card Assembly to make a
SMALL flip panel using Grapefruit Bliss cardstock on a white
card, layered onto the inside of a 5 1/2” x 8 1/2” Grapefruit Bliss
base that has been folded in half.
Stamp “today or your birthday” saying onto 1 3/8” x 1 3/8”
white cardstock. Line edges with pencil and blend with Gamsol.
Stamp birthday flock image onto 2 3/4” x 4” white cardstock.
Color with pencils and blend with Gamsol.
Adhere saying piece to outside of flip flop panel.
Stamp “Happy Belated Birthday” saying onto 1 3/8” x 1 3/8”
white cardstock. Line edges with pencil and blend with Gamsol.
Adhere saying piece to inside of flip flop panel.
Phone: (800) 945-3980
7.
8.
9.
10.
Close card, and use ribbon slot punch along bottom edge of card front. Thread ribbon through slots.
Adhere 2 3/4” x 4 1/2” Kraft cardstock to center of card front.
Tie extra ribbon into bow and attach to lower right of Kraft panel.
Stamp running chick image onto 2 1/2” x 2 1/2” white cardstock. Color with pencils and blend with Gamsol, and
use corner rounder punch as shown in sample photo.
11. Stamp “Which came first” saying onto 1 1/2” x 1 1/2” white cardstock, and use corner rounder punch as shown in
sample photo.
12. Adhere image and saying pieces to Kraft panel.
Under The Feather
Stamp Set & Die:
11288SC Make It Better
Chicks Clear Set
Cardstock:
White
5-5128 Apple Crush
7-7119 Caribbean Breeze
9-960 Kraft
Other Supplies:
Black Dye Ink Pad
Colored Pencils
Black Fine-Tipped
Marker
1. Follow instructions for Basic Flip Flop Card Assembly to make a LARGE flip
panel using Kraft cardstock on an Apple Crush card, layered onto a
Caribbean Breeze base.
2. Stamp sick chick image onto 2 3/4” x 4” white cardstock. Color with pencils
and blend with Gamsol.
4. Attach 1/2” x 2 3/4” Caribbean Breeze strip at top of flip flop panel.
5. Stamp “Heard you were under the feather” saying onto 3/4” x 2 1/2” white
cardstock.
6. Line edges of saying piece, and adhere to top of flip flop panel.
7. Open flip flop panel, and attach 1/2” x 4” Caribbean Breeze strip at top of
Apple Crush card.
8. Stamp “Hope you feel better soon” saying onto 7/8” x 2 1/8” white
cardstock.
9. Line edges of saying piece, and adhere to upper part of Apple Crush card on
top of Caribbean Breeze strip, underneath flip flop panel.
Phone: (800) 945-3980
Chicks Rule
Stamp Set:
11290SC Girlfriend
Chicks Clear Set
1.
Cardstock:
White
2-235 Cherry Splash
9-960 Kraft
Other Supplies:
Light Blue Dye Ink Pad
Black Dye Ink Pad
Colored Pencils
Follow steps #1-6 in the instructions for Basic Flip Flop Card
Assembly to make a MEDIUM flip panel using Kraft cardstock
on a white card, layered onto a Cherry Splash base.
EXCEPTION: Steps #8-11 below show how to make the pullout message strip, which will need to be inserted into flip flop
panel before closing up with adhesive.
2.
3.
6.
Trim rounded pull tab to 1/4” past score mark, if desired.
Stamp girlfriend chicks image onto 2 1/4” x 3 1/2” white
cardstock. Color with pencils and blend with Gamsol.
Adhere image piece to flip flop panel.
To create pull-out message strip, run larger main die through
die cutting machine again, this time with Cherry Splash
cardstock.
Cut off both long side flaps from piece, so it looks like this:
7.
Then remove both short, wider side flaps (but not the narrow pieces), so it looks like this:
4.
5.
Phone: (800) 945-3980
8.
After completing step #6 (i.e., scoring the flip panel in half) of the Basic Flip Flop Card Assembly instructions,
attach the top edge of the Kraft panel beneath the top flap of the white mechanism, making sure to center the
Kraft panel horizontally onto the white card. In other words, keep the same amount of white space on the left
and right sides of the white panel.
Then lay the pull-out message strip onto the center of the Kraft half-panel, indicated by the arrow below. Make
pencil marks on the right edge showing where the pull-out message strip will be placed. Then put double-sided
tape or dry adhesive around remaining edges as shown, being careful not to get any in between the pencil
marks.
Arrow shows
where to place the
pull-out message
strip before
marking right edge
with pencil.
9.
Attach a 3/4" x 3 3/4” barrier strip (shown below in yellow, but can be any color) to lower part of white
mechanism flap on the reverse side of the flap. This piece will keep the pull-out message strip from getting stuck
inside the card.
Arrow shows
where to place the
adhesive on the
reverse side on
white mechanism,
to attach the yellow
barrier strip.
Phone: (800) 945-3980
10. Stamp “Chicks Rule” onto 3/4” x 3 1/8” white cardstock, and adhere to pull-out message strip. Place adhesive on
left and right edges of barrier strip:
Arrow shows
where to stamp the
saying onto white
piece and adhere to
pull-out message
strip.
Make sure the white saying and pull-out message strip are positioned underneath the yellow barrier strip:
11. Pull off tape liners, fold up lower half of flip flop panel, and adhere to upper half of flip flop panel. When message
strip is pulled out, this is what it will look like:
Phone: (800) 945-3980
Flower Chick
Stamp Set & Die:
11287SC Celebrating Chicks
Clear Set
Cardstock:
White
4-443 Grapefruit Bliss
9-960 Kraft
Other Supplies:
Black Dye Ink Pad
Colored Pencils
1. Follow instructions for Basic Flip Flop Card Assembly to make a SMALL flip
panel using Grapefruit Bliss cardstock on a white card, layered onto a
Grapefruit Bliss base.
EXCEPTION: Change dimensions of Grapefruit Bliss flip flop piece to 2 1/4” x
5 1/2”, scored and folded in half to make 2 1/4” x 2 3/4” panel. Position panel
onto card as shown in photo.
2.
2. Stamp flower chick image onto 2” x 2 1/2” white cardstock. Color with
pencils and blend with Gamsol.
4. Stamp “Just chicken in to say hi” saying onto 1 1/2” x 1 3/4” white cardstock,
and layer onto 1 3/4” x 2” Kraft cardstock.
5. Adhere layered saying piece to center of white card inside, underneath flip
flop panel.
Phone: (800) 945-3980

Flip Flop Card Instructions

Transcription

Similar documents

Concentric Kirigami - Blick Art Materials

Flip Flop Shops Steps into Greenville

Instructions for Revealing Oval Cards

HoneyPOP Border Instructions

What Are The Odds Of A Shark Attack?

HoneyPOP Flower Instructions

Spring 2016 - Inky Antics

INKY WINTER 08 FLYER.qxd

Picasso minibook

Sprint AIR - Veterinary X-rays

custom truck accessories

Cable Management System - Custom Products and Services

Google Doodle for Penny Black`s 175th

mcaa 2014 swcas - Center for East Asian Studies

david banner - Ozone Magazine

DEPOSIT BONUSES TO GET STARTED

"How To" Advice for Beginning PPC Collectors

IMxVCD Help

Arun Shukla, Puneet Kumar Dept. of Mechanical, Industrial

Dreamweaver CS4 - MYY web server

Decide to Play Great Poker: A Strategy Guide to No

Postal Bulletin 22082 - August 8, 2002