Instruction Manual

Wireless Remote:
Scews
Plug & Play Wireless Remote
(Electric PN: 7076) (Hydraulic PN: 7077)
Kill
Switch
Step 1: Unscrew and Remove the Kill Switch
NOTE: Mile Marker’s Standard Solenoid boxes have 2
screws on each side, as shown in the image above. Remove
these screws and lift box cover up.
Unpacking Your Wireless Remote
Unpack your new Plug & Play Wireless Remote and ensure
that all the parts are included by referring to parts list and
exploded view drawings provided in this manual.
In the box:
1. Screws
2. Pig Tail (Plug)
3. Remote
4. Control Box
Step 2: Remove Kill Switch first, then Remove Solenoid Cover
IMPORTANT: If your control box has
any other pin configuration other
than the two below, please contact
Mile Marker’s Tech Department at:
(800) 886-8647
Black
Brown
Green
White
Standard 3 Pin
IP67 Waterproof
Installation:
If your Mile Marker winch features the IP67 waterproof connection, then simply plug the receiver box into your solenoid
box just as you would your wired remote control. The wireless receiver has a toggle switch for power, and once “ON”
(indicated by a RED light), the unit is ready for use.
Black
Brown
White
Green
For all other models, please follow the instructions at right:
Step 3: Wire the Pigtail According to Above Diagram and Picture
NOTE: This diagram illustrates proper
wiring connection from pigtail to solenoid.
installation options:
There are many options for the placement of your new plug. Here are a few options we suggest:
(3-1) Slide plug under the Solenoid Box and attach accordingly on the outside of Solenoid.
(3-2) Drill the top side of the box cover, on the right side of the Mile Marker logo. Then slide in the head of the pig tail (the plug).
(3-3) Drill the right side of the box cover, toward the top. Then slide in the head of the pig tail (the plug).
(3-4) This is a sample of what our Standard Solenoid Box looks like after drilling the new hole on the top right of the box.
3-1: remove Power switch first.
3-3: Drill right side of Box Cover.
3-2: Drill top right of the Box Cover.
3-4: sample of solenoid Box With two Plugs.
Warranty information:
2121 BlouNt roaD
PomPaNo BeaCH, Fl 33069 usa
WWW.milemarKer.Com
[email protected]
800.886.8647 toll Free
954.782.0604 usa & iNt’l
954.782.0770 FaX
©Copyright 2012 mile marker, inc.
Mile Marker warrants each Wireless Winch Remote Control, when used in normal service, against
factory defects in material and workmanship, to the original purchaser for a period of 1-year. There are
no warranties, expressed or implied which extend beyond the original purchaser. The loss of use of the
vehicle, loss of time, inconvenience, commercial loss, or consequential damages is not covered.
Mile Marker reserves the right to redesign and make any changes to any product without assuming any
obligation to modify any product previously manufactured.
This warrant gives you specific legal rights. You may also have other rights which vary from state to
state. Some states do not allow limitations on how long an implied warranty lasts. Some states do not
allow the exclusion or limitation of incidental or consequential damages. Therefore the above limitations
or exclusions may not apply to you.
all products requiring warranty service must recieve a Returned Goods authorization Number (RGa)
before being sent freight prepaid to Mile Marker. This can be initiated by calling 1-(800) 886-8647.