Etag Belgesi 2013

Comments

Transcription

Etag Belgesi 2013
r
v
,
,
'_
®TECHNICKY A ZKUSEBNI USTAV STAVEBNI PRAHA,
Zl'js
II
r~;t~~l
~~!bn~I~~atJ~~o~iZ!~n~
!!!b~,~~rti!k~C~i
Accredited
Testing Laboratory,
Authorized
Body, Certification
Prcsecka 811 /76a, 19000 Praha 9 - Prosek, Czech Republic
O~~,~!i~!a~:~~~~
Body,
Notified
Body,
In~!k~n~O~!
Inspection
Body
EC CERTIFICATE
OF FACTORY PRODUCTION CONTROL
C. 1020 - CPD - 090-021414
In compliance with Council Directive 89/106/EEC
of 21 December 1988 on the approximation of laws,
regulations and administrative provisions of the Member States relating to construction products
(the Construction Products Directive or CPD), as later amended, it has been stated that the construction
product:
SP Star Euro Plastic Nail Pegs
Type: SP Star Euro La (90-160mm), anchor diameter Bmm, plate diameter 60mm
Plastic nailed-in anchors for fixing of external thermal insulation composite systems with
rendering in cocrete
placed on the market by
STAR PLASTic YAPI ELEMANLARı iZOLASYON
MALZEMELERi SAN. Ve Tic. A. Ş.
Address:
ORTAKÖY MERKEZ MAH.DUMlUPINAR
CADDE NO:44
sıuvaı , ıSTANBULlTÜRKIYE
and produced
in the factory
STAR PLASTic YAPI ELEMANLARı iZOLASYON, MALZEMELERi SAN. Ve Tic. A. Ş.
Address:
ORTAKÖY MERKEZ MAH.DUMlUPINAR
sıuvnı IISTANBUlITÜRKjYE
CADDE NO:44
is submitted by the manufacturer to the initial type-testing of the product, a factory production
control and to the further testing of samples taken at the factory in accordance with a prescribed
test plan and that the notified body No.
1020 - Technical
and Test Institute
for Construction
Prague
has performed the initial inspection of the factory and of the factory production control and performs
the continuous surveillance, assessment and approval of the factory production control.
This certificate attests that all provisions concerning
described in ETA
the attestation
of factory production
control
E1A-08/0340, valid from 22.04.2013 to 21.04.2018
were applied. For detailed information in relation to the performance characteristics of the
productıs), the ETA itself, mentioned above, should be consulted.
This certificate was first issued on 19 April 2009 and remains valid until the date of expiry of the
ET A as long as the conditions laid down in the ETA in reference or the manufacturing conditions in
the factory or the FPC ıtseıt are not modified significantıy
The stamp of the Notified Body1020
Prague, 10.5.2013
s.p.
Ing. Jii'i Studniöka
Deputy manager of the Notified Body

Similar documents