Jens Bangs Stenhus. Facade mod Østerå gade

Jens Bangs Stenhus.
Facade mod Østerå gade
Here is my version of Jens Bang's House. I had a desire to cut many of the fine ornaments, but abandoned it as
too big a challenge.
General assembly instructions: Cut thea piece out and glue them on cardboard. Cut out the white windows and
doors. Glue it on the b pieces.
a
b
Handrails are tinned copper wire which are soldered together. The
poles are bent in and is held tightly by the paper that I glued on.
The small turret on the front.
Stairs, I made out of cardboard that
is glued together in a layer
Glue the two pieces of cardboard.
In the "turret" I have
raised them in a few
cardboard pieces .
This house should really be 8-sided, but I
settle for six. Glue them on a thin cardboard and assemble them into the tower.
The plate is glued
to the stairs and
the hexagonal tower on top of
completely against
the wall.
Pieces that can be used to glue on the stairs.
Spire, I have
made in Cernit
and glued it on
the roof.
The roof is glued on cardboard
Gavl mod syd.
a
b
Nordgavl
a
The back
a
b
Stair tower at the rear of the house
The two small houses on both sides of
the stair tower.
Tag
Tag
Glued on cardboard and glued on
the inside of the end gables.
135 mm
87 mm
67 mm
The roof of the building. Glued on cardboard and cut out. Scratches along the red line.
122 mm
These shapes are
glued on
cardboard and
cut out ..
They are glued
on the inside of
the attic gables
on the facade.
The roof to the attic. Glued on cardboard and
scratch along the red line.
Chimneys. I glued them onto thin cardboard and scratched at the bends.
On the backside, I glued a small piece of paper to collect it.
The roof of the attic on the back.
The roof of the stair
tower. It is folded
like a puramide.