oUR fAVORITE Bushing tools and more for Mercedes

Comments

Transcription

oUR fAVORITE Bushing tools and more for Mercedes
oUR fAVORITE Bushing tools and more for
Mercedes- bmw-vw-audi and volvo
=
+
#B313000
#B313000PLUS
#B313000ADD
Hydraulically driven, this kit quickly removes and
installs the metalastic bushing in the
traction strut with the strut still in the car.
Includes hydraulic ram, pads and tubes.
Hydraulic pump not included. 10 Ton recommended.
Chassis: E32, 34, 38, 39, 53, 60, 65, 66, 70, 90, 91,
92, 93, M3 You can buy the #B31300ADD to add to your #B313000.
+
=
#B333351
#B333351PLUS
#B333351ADD
Use to remove and install upper control
arm bushing (1), lower control arm
bushing (2) and front trailing arm bushing
(3) on both E36 and E46 chassis (3
New Style Bushing Old Style Bushing
series 1992-2005). Also fits upper and
control arm bushing on E85 (Z4).
Does not fit Z4 trailing arm bushing. You can buy the #B333351ADD to add to your #B333351
#B312240K
Use to remove the control arm from the steering
knuckle. 27mm, 31mm adapters
E38, E39, E52, E53, E60, E61, E70, E71, E83, E90,
E91, E92, R50, R52, R53, RR1, RR2
#B334191
Use to remove and install the rear axle
lower ball joint/bushing. E38, E39
800-848-6657
Differential and subframe
bushing tools
BMW
Mercedes
Front Bushings #B333360
Rear Bushing - #B333370
Complete kit #B333390
(E36, E46) and Z4 (E85) & E83, E86, E87
#B334160
Differential bushing Extractor/Installer
E39
#B210-0243
Rear Differential Bushing Extractor/Installer
W210 chassis
#B1819
Differential mount bushing remove and install
124, 140, 201
#B334140
Rear axle carrier
subframe bushing
remover and installer
E46 and Z4 (E85)
#B334140X5
Rear axle carrier
subframe bushing
remover and installer
E53
#B334150PLUS
Sedan and wagon
Rear Sub Frame
Bushing Remover
and Installer
E39
800-848-6657
#B140-0333
Rear axle carrier
mount bushing puller
front/rear
W140
#B1838
Rear axle carrier
mount bushing kit
W124, W201
#B210-0143
Rear subframe
bushing extractor/
installer W210
#B203-0043
Rear axle carrier
mount bushing kit
W203, 209, 171
sTOP DAMAGING THOSE
FUEL TANK RINGS
Mercedes Benz
BMW
161020
161190
Fuel Tank Lid Socket
Chassis: F01, F02
Use to remove and install the
fuel level sending unit found
on most late models. 1 Piece.
For later models with side
ridges use #203-0107.
VW/Audi
T40068A
T10202
AUDI - A6 2005 and
Fuel Sending Unit
later A8 2003 and later Wrench. Cayanne,
A6 2005 and later, A5 Touareg,Audi Q7
2007 and later
3217
3307
Removes and installs
Wrench for removing
139mm fuel gauge sending and installing the fuel
unit retainer nut.
pump.
Volvo
164-0107
Fuel tank level sender
wrench 164 and 251
001-0007
Fuel Tank Lid Socket
Chassis: 204, 212
202-0007
Use to remove fuel sender
retainer nut. W202
210-0107
Pin wrench for removing
and installing lever-type
fuel level sensor. W140,
210
163-0037
Allows quick release of fuel pipe
connections (quick couplers), particularly the fuel pump connection to
delivery sensor unit. W163, 203
M0035A
#V5720
Volvo Fuel Sender
Wrench S80 (-06), XC90,
V70 (00-08), V70 XC (01-) /
XC70 (-07), S60
#7093
Removes the
fuel sender ring.
V70 (08-), XC70 (08-),
C30, C70 (06-), S40(04-),
V50, S80 (07-)
Use to remove fuel tank
filter body and fuel gauge
sending units.
203-0107
Fuel tank level sender wrench, Also fits most
BMW fuel senders. W163, 203, 209, 211, 219.
800-848-6657
tOOLS TO GET
THE JOB DONE
Covers:
•Mercedes
•BMW
•VW/ Audi
•Porsche
•Volvo
•Toyota/Lexus
•Nissan/Infinity
•Honda/Acura
•Other Asian Makes
•Domestic
The B90K is a press kit that REMOVES and
INSTALLS front and rear wheel bearing with the
spindle ON THE CAR.
#1117J
Compresses all types of MacPherson
style coil springs front and rear.
Includes three sets of jaws
•75-110mm •110-140mm •140-190mm
Fits most BMW’s and many other vehicles.
#924-0231
This kit quickly pushes the axle out of the hub,
and removes the hub. Includes: hydraulic ram,
4 lug and 5 lug adapters, and slide hammer.
Hydraulic pump not included.
10 ton recommended
#1117V
Vice for Shock Absorber
Compresses front and rear axle springs in the
car on models with idler arm Chassis: 107,
114, 116, 123, 124, 126, 129, 140, 164, 170,
171, 201, 202, 203, 204, 208, 210, 211, 219
#1117JBMW
Spring Compressor
Adapter E39 E46
#220-0343
Presses the ball joint into the steering knuckle
on 211 (E-class from 2002); 215 (CL-Class from
2002); 219 (CLS-Class from 2006); 220
(S-Class from 2000); 230 (SL Class from 2003)
800-848-6657