The Elite Series Bobcat Trailer comes standard with tandem 5,200lb

Finish Line trailers are built for the abuse that they take on the job site, and our Elite Series Bobcat trailer is no exception. Built
heavier that most equipment trailers on the market today, our Elite Series Bobcat trailers come standard with 3” channel
crossmembers on approximately 16” centers. The 9,990lb and 12,000lb GVWR Bobcat trailers come standard with a 6” channel
frame and 5” wrap around channel tongue and the 14,000lb GVWR trailer comes standard with an 8” channel frame and 6”
channel tongue.
The Elite Series Bobcat Trailer comes standard with
tandem 5,200lb, 6,000lb, or 7,000lb brake axles, equating
to a 9,990lb, 12,000lb and 14,000lb GVWR, break away
kit, and a 7-prong RV style electrical plug.
Elite Series Bobcat trailers come standard with two
different styles of fenders. The 10K and 12K models
come standard with a 12-gauge smooth fender (shown
above) with (1) center brace and ATP on the fender fronts
for added protection again rock chips. The 14K comes
standard with a 3/16” formed drive over fender (shown below)
for a studier fender for heavy equipment.
9,990lb GVWR Bobcat trailers have a standard 25/16” Aframe coupler (shown above) and 12,000lb and 14,000lb
GVWR Bobcat trailers have a standard 25/16” Adjustable
height coupler (shown right) for adjusting to the hitch height
of your vehicle.
RED OAK MFG., INC. ♦ 2400 N BROADWAY ST ♦ RED OAK, IOWA 51566-1019 ♦ 712.623.6021 PHONE ♦ 712.623.6961 FAX
WWW.FINISHLINETRAILERS.COM
Elite Series –Bobcat – Page 1 of 2
If you have ever seen an equipment trailer with bent ramps or if you have cut a tire due to the sharp angles of the ramps, you
haven’t seen a set of ramps like our Elite Series Bobcat style stand-up ramps. These ramps are built out of ¼” steel formed into 3”
channel that surrounds the 3” channel rungs. The ramps also have a taper cut (shown above left) on the ends to help eliminate tires
being cut on sharp edges.
The ramps are hinged with a double-hinged mechanism (shown above center) that also slides in towards the middle of the trailer or to
the outmost width of the trailer to accommodate your equipment width. The double-hinged mechanism allows for easier loading
while on uneven ground. Add the optional 2’ dovetail (shown above right) to decrease your loading angle.
A 10” tall formed headache rack
provides a nice flowing design
to the Elite Series Car Hauler
models. And a 12K drop-leg
jack comes standard as well!
Add a gooseneck option
(shown to right) or you can
We also offer an upgrade option for a
3rd bobcat ramp. This 3rd ramp is an
outstanding addition for narrow front
tractors or 3 wheeled walk behind
trenchers.
also choose from one of
our 5 standard colors (no
upgrade charge for our
colors!) available: CAT
Black, Smoke Grey,
Carmine
Red,
CAT
Yellow, and John Deere
Greene.
RED OAK MFG., INC. ♦ 2400 N BROADWAY ST ♦ RED OAK, IOWA 51566-1019 ♦ 712.623.6021 PHONE ♦ 712.623.6961 FAX
WWW.FINISHLINETRAILERS.COM
Elite Series –Bobcat – Page 2 of 2