TDV6 Power Box 2 Fitting Instructions

Powerbox 2
1.
Range Rover Sport / Discovery TDV6
FITTING INSTRUCTIONS
Under the bonnet, remove the engine cover shown in Photo 1.
Remove the oil filler cap, then gently ease the engine cover
upwards in the positions indicated by the arrows (no tools are
required, as the cover is a push-on/pull-off fit). When the cover
is removed, temporarily replace the oil filler cap.
2.
Next, referring to Photo 2, locate the connector at the rear of
the engine. The correct connector (shown in the enlarged
window), has three wires and an arched top.
Unplug the connector from the vehicle and plug the Powerbox
2 female connector in its place. Then plug the Powerbox 2
male connector into the female plug which was removed from
the engine.
Finally, secure the Powerbox 2 in a dry location, away from
excessive heat and vibration and replace the engine cover.