RAW STEEL SHEET - temcocontent.com

AR500
RAW STEEL SHEET
SPECIFICATIONS
Material:
AR500 Steel Armor / Wear Plate
Composition (typical):
Carbon: 0.31
Manganese: 1.50
Phosphorus: 0.025
Sulfur: 0.015
Silicon: 0.50
Chromium: 0.87
Nickel: 0.70
Molybdenum: 0.35
Boron: 0.003
Thickness:
3/16”, 1/4”, 3/8“, 1/2”, or 3/4“
Shape:
Circle Gong
Mounting Holes:
2 Holes, 1" diameter -0.00"/+0.12
Diameter (in):
Varies
Hardness:
Brinell 450 min / 500 nominal
Tensile:
247 ksi TYPICAL
Yield:
184 ksi TYPICAL
Elongation:
11.1% in 8”
Impact Strength:
CVNL average 20 ft. lbs at -40°F
Cutting:
Can be cut with plasma, oxy-acetylene, laser, and water jet, as well as with abrasive cut off saws.
Machining:
Drilling, countersinking, counterboring, tapping, milling, and general machining can be done
with conventional equipment and carbide tools.
Forming:
Generally not formable due to high strength and hardness. However, forming is possible with
inside radius of at least 10 x plate thickness and bend axis transverse to rolling direction.
Welding:
Low-hydrogen-producing electrodes must be used in welding. Where maximum strength of
joining plates is not important, rod type AWS E7016, 15, or 18 should be used. If possible, 7018
and 8018 electrodes should be used with the 500 BHN steel. If the weld is to be subjected to wear,
it may be capped with a hard facing electrode having a low hydrogen type coating. When higher
weld strengths are required, electrodes of the AWS E90, E100 or E120 low hydrogen series should
be used, depending on the strength levels required.
Applications:
www.temcoindustrial.com
Mining equipment, Earth moving contact parts, Conveyors
Phone: (510) 490-2187
Fax: (510) 490-1507
48621 Warm Springs Blvd
Fremont, CA 94539, USA
Specifications may vary and are subject to change. For certified drawnigs and specifications, please contact a TEMCo representative.
AR500
RAW STEEL SHEET
TOLERANCE SPECIFICATIONS
Size Deviation: Actual part may deviate from specified
Edge Bevel: Edges may exhibit a bevel of upto +/- 15 degrees
measurement by +/- 0.120”
or may include original mill edge which will contain a radius.
Surface Features: Surface may contain pits, scratches and
Cut Process: Liquid Cooled Plasma Arc
light gouges typical of handling heavy plate.
Surface will not be prepared in any way and comes with
raw mill finish.
www.temcoindustrial.com
Phone: (510) 490-2187
Fax: (510) 490-1507
48621 Warm Springs Blvd
Fremont, CA 94539, USA
Specifications may vary and are subject to change. For certified drawnigs and specifications, please contact a TEMCo representative.