manual - silex technology

Network printing
on a Dymo LabelWriter 400 Duo
with the SX-2000WG
This is a step by step manual how to install the print server SX-2000WG
to network the Dymo LabelWriter 400 Duo.
The setup is exactly the same for the SX-2000U2 and the SX-1000U.
Dymo LabelWriter 330 Turbo, 320, 310, 400 Turbo, 400, 400 duo
are supported by these silex print servers:
SX-5000U2, SX-1000U, SX-2000U2, SX-2000WG, SX-3700WB.
SX-5000U2 and SX-3700WB use different printing methods –
please use JC-Print Port 2002 or printing over NetBios
(different step by step manual is available at [email protected]).
Before you start:
This setup shows how it works on „Dymo LabelWriter Software Version 7.0 for
Windows“ – lower versions might vary.
Configure the SX-2000WG to make it available on the network
(Quicksetup e.g.).
Connect SX-2000WG to the network and to your Dymo LabelWriter.
Install the SX-Virtual Link application.
( SX-Virtual Link Version 1.3.0 is used in this setup – older versions might not have the auto connect feature)
Download latest version from our website:
http://www.silexeurope.de/euro/support/printserver/virtuallink.html
Please start SX-Virtual Link first, then start the setup from
CD – choose your language.
It is important that you start SX-Virtual Link for later
If necessary please adjust the path
Now press ALT + TAB to switch between the processes
(keep ALT pressed and switch with TAB)
Switch so SX-Virtual Link
Connect with the Dymo LabelWriter DUO
Wait until the hardware is found and all drivers are installed
Please notice:
The next steps to change the printer drivers are only necessary on the
Dymo LabelWriter 400 Duo:
If you do not have a Dymo LabelWriter 400 Duo
please switch to page 25.
At „Start“, „Settings“, „Printer and Faxes“
the Dymo LabelWriter is now available.
For the second LabelWriter DUO Label (Copy 1)
we need to change the drivers to
support the tape printer function.
2
1
3
Please move to Manufacturer DYMO and
select the DYMO LabelWriter DUO Tape
2
1
Now both printers are
available.
The 2 Dymo LabelWriters are now available as
if they were locally connected: Label Writer
Only for Dymo LabelWriter 400 Duo!
The 2 Dymo LabelWriters are now available as if
they were locally connected: Tape Writer
Auto connect feature
• If you don‘t want to enable the connection each time you
can enable the auto connect feature. The software SX-Virtual
Link will check the printer queue and connect automatically
once there is a print job in the queue. This feature enables
your device server to act like a real print server.
• Connect in SX-Virtual Link to the Dymo device.
• Go to the „Add to Favorites“ menu, enable the function at
„Printer option“.
2
3
1
4
Well done!
•
Your Dymo LabelWriter is now availabel for any client from your
network. Please repeat the steps on each client. SX-Virtual Link only
supports one client connected at a moment.
•
If you have any futher questions concerning the installation of your silex
product please contact us:
[email protected]
•
For Information where to buy the SX-2000WG and other silex print
servers please check our website
www.silexeurope.de or contact [email protected].
Copyright © 2006 silex technology europe GmbH