UTV POLARIS RANGER RZR Plow Mount Instructions - Agri

Plow Mount Parts
UTV POLARIS RANGER RZR
Plow Mount Instructions Kit #60044
Lock nuts
U-bolts
Flat washer
Lock nuts
U-bracket
Hitch pin clip
Mount plate
Bolts
Hitch pin
Tools: T27 torx
9/16” wrench (2x)
ft. lb. torque wrench w/ 9/16” socket
Protective eyewear
Receiver
1
Remove
these 4 bolts
U-bolts
Mount
Plate
a) At front of machine, remove 4 bolts
on shield with T27 torx wrench.
b) Pull bottom of shield away from machine far enough to allow front of
mount plate to fit behind shield and
up against frame.
c) Support mount plate up in position.
Install U-bolts from behind around
frame tube and into holes of mount
plate. Turn lock nuts on both Ubolts.
2
Lock
nut
Washer
& bolt
Insert 2 bolts up
from bottom
U-bracket
a) Behind front drive train, place Ubracket on top of frame between
tubes under cable. (Also see photo
2c at right)
b) Insert bolt up through bottom of
mount plate and through hole in Ubracket (2 bolts).
Mount plate
U-bracket
c) Place flat washer over each bolt and
turn lock nut onto each.
(continued on back)
Page 1 of 2
PN 50331_A
© Copyright 2013 Agri-Cover, Inc. All Rights Reserved
081613
(continued from front)
3
Bolts
a) Photo shows both bolts in place under back of mount plate ready to be
tightened.
b) Using 9/16 wrenches, hold nut at top
and tighten bolt from bottom. Repeat
for each bolt.
c) At front of machine tighten and
torque nuts on each U-bolt to 31
ft. lbs.
Next torque (2) bolts under mount
plate to 31 ft. lbs. (See 3a & 3b at
left)
4
Tighten
Tighten
a) At front of machine, insert (2) top
bolts (removed earlier) into shield
and tighten with T27 torx.
b) Then tighten bottom 2 bolts on shield
with T27 torx.
5
Hitch pin
Hitch pin clip
a) Insert prong of receiver into notch
under rear of mount plate.
b) Lift front of receiver up and insert
hitch pin through holes on mount
plate and through receiver to opposite side.
Page 2 of 2
c) Insert hitch pin clip. Installation is
complete. Periodically check torque
on bolts and retighten if needed.