DWV335_Datasheet copy

Data Sheet Includes Information On
Vesta
Side view (not to scale)
Product Model Number
DWV335BBS
Vesta Space Saving Built-In Dishwasher
Installation Location:·
· Must be installed on a solid, level surface.
Front view (not to scale)
17 ¼”
Electrical Requirements:
· Machine Voltage/Amperage: 120V, 60 Hz,
5.72 Amp
· Connection: 3-prong plug with 6' (182.8 cm)
cord is provided with unit.
· Circuit Protector: 15 Amp.
18 5⁄8”
2 ½”
10 ¾”
Incoming Water Pressure:
· Between 10 and 145 psi (.04 and 10 bar) for
best operating results
Specifications
· Capacity: 6 Place settings
· Drying Method: Convection
· Weight: 61 lbs.
· Water Usage: 2.4 to 4.2 Gallons
· Color: Black
· Hot Water Connection: 140° F max.
(unit has an internal water heater for cold
water hook up)
¾”
5⁄8”
20”
23 ¼”
Side view, door open (not to scale)
Rear view (not to scale)
21 11⁄16”
Water Inlet Hose
· The water inlet hose from the machine
terminates in a 3/4” ‘female’ connector. The
water supply should terminate in a similar
‘male’ connector and should have a shut off
close by.
Drain Hose
· Make sure hose is sealed properly to the ‘y’
branch. Hose should be secured if standpipe
is used. Outlet hanger provided.
Electrical
Drain and Water
connection
Below Countertop Install
37”
Sink
Y Branch
Built-in cutout dimensions (not to scale)
12”
Above Countertop Install
17 9⁄16”
Sink or floor standpipe drain
Electrical, drain, and
water connections
can be accessed
from either side
SINK DRAIN
Standpipe
Y Branch
1” min
3 ¼”
1⁄16”
21 1 in.
m
Outlet
Hose Hanger
Sink
4”
FLOOR
STANDPIPE
DRAIN
21 15⁄1
6”
1½” ID Standpipe min.
Never reuse data sheets. Data sheets are subject to change without notice. Never use data sheets for final installation criteria. Complete
installation instructions are available upon request and in the owner's manual that comes with the unit. Copyright 2011 Westland Sales.