FTTH Guide

Fibre to the Home (FTTH) Quick Set Up Guide
Step 1: Connecting the Fritz!Box modem
Connect the Ethernet cable from the ONT as per diagram
to the LAN 1 port on the back of the Fritz!Box. Please note
that the DSL port is not used with this product.
r/
we
Po
L
DS
et
rn
te
In
e
Leintz
edtn
Fixes
N
LA
W
fFoO
InN
Step 2: Broadband Talk Setup
t
In
fo
W
LA
N
Fi
xe
d
Li
ne
ne
In
te
r
Po
w
er
/D
SL
If you have opted for Digiweb’s Broadband Talk VOIP telephone service,
as per diagram, please connect your telephone to the “FON 1” port on the
back of the Fritz!Box to start using your VOIP telephone service. If you
have opted for Digiweb’s fixed line telephone service, please connect
your telephone to the telephone socket as installed by the telecoms
engineer during the installation process.
Step 3: Wireless Network Security Key / Wifi Password
• Ensure that the WLAN LED is ON steady green.
If the WLAN LED is off, press the WLAN button (do not hold down).
Wait for the WLAN LED to go steady green.
• Select the Fritz!Box wireless network on your device.
• Enter the “WLAN Network Key (WPA/WPA2)” key into the
“Security key” box open on the screen of your device.
• Enter the security key as provided on the
sticker attached to the base of the Fritz!Box.
WLAN
DSL/TE
FON
LAN 1
LAN 2 LAN
3 LAN
FRITZ!Box Fon WLAN 7360
WLAN Network Key (WPA/WPA2):
Installation:http://fritz.box
Serial No.:
Part-No.: 2000 2448
Use only with the power unit:
311P0W062
12V 2A 24VA
© AVM GmbH
www.avm.de
Made in Germany
Troubleshooting: LED Operation
Power/DSL
Flashing green: DSL Connection / Sync is attempting to establish.
Please ensure DSL phone cable or Ethernet cable is NOT connected to the DSL port.
On (solid green): Ensure that the Ethernet cable is connected to LAN 1 Connection should
now be online as per pre-configured settings.
On (solid red): Power failure. Please ensure correct provided power supply is in use.
Contact Digiweb Technical Support if powering off and on does not fix this.
Internet
(VOIP Phone Service)
Flashing green: You have new VOIP messages in your Fritz!Box telephone service inbox.
Fixed Line (Phone Service)
Not applicable.
WLAN
Flashing green: Adopting the Wireless/WiFi settings
On (solid green): A telephone connection on your Digiweb VOIP service is active.
On (solid green): Wireless / WiFi are active. Please refer to Step 3.
Info
Flashing green: Configuring / Configurable e.g. firmware update.
DO NOT POWER OFF when this LED is flashing!
On (solid red): Configuration error – please power off and on the Fritz!Box.
Contact Digiweb Technical Support if powering off and on does not fix this.
Broadband and Telephony Technical Support Telephone: 1918 or 1890 940 400 option 2 Email: [email protected]
Customer Care Telephone: 1918 or 1890 940 400 option 1 Email: [email protected]
Sales Telephone: 1800 28 58 28 Email: [email protected]
Thanks again for your custom and we hope you enjoy your new Digiweb Fibre service.