TMW-10 Loggers Saw Horse Assembly Instructions

TMW-10 Loggers Saw Horse
Assembly Instructions
A
Step#1: Connect 2 Brackets with the serrated jaws
(Part# A) together as shown in Figure 1 using one
5/16” x 1-7/8” Hex Screw & Nut (Part# D in the
upper set of holes.
Next insert the 3/16” x 5/8” Hex Screw & Nut (Part#
E) through the lower slot as shown in figure 1.
Repeat this step two more times so that there are
3 sets of brackets.
D
E
Figure 1
A
A
A
Step#2: Connect 2 sets of brackets with the serrated
jaws (Part# A) to Connecting Bar C (Part# C) using 1
3/16” x 5/8” Hex Screw & Nut (Part# G). See Figure
2.
Please note that you will attach the 3rd set of
brackets (Part# A) in the next step.
G
G
C
Figure 2
Step#3: Attach Connecting Bar B (Part# B) to the 2
Brackets from Step # 2 using the 3/16” x 5/8” Hex
Screw & Nut (Part# G) as shown in Figure 3.
Next overlap Connecting Bar C (Part# C) and
Connecting Bar B (Part# B) with Connecting Bar C on
top and attach to the 3rd set of Brackets (Part# A)
using the 3/16” x 1-1/8” Hex Screw & Nut (Part# F).
G
G
Repeat Step#’s 2 & 3 for the opposite side of the
Loggers Saw Horse.
B
Figure 3
F
Parts Breakdown