CREA Single Station Thermoforming Machine CREA 0805

CREA Single Station Thermoforming Machine CREA 0805

Single Station Thermoforming Machine
CREA® 0805-03 and 1007-04
MAIN CHARACTERISTICS
•
Siemens heating control and PLC - high efficiency
•
Upper & Lower double heaters
•
Heating Cycle pyrometer
•
Upper IR-Heating lamps individually controllable - 125 x
60 mm length
•
Lower IR-Heating lamps individually controllable - 250 x
60 mm length
•
Sealed mold box (sag control, pre-stretching, bubble)
•
“Technological platform” where all the platen motor controls are placed to allows easy maintenance, movement
lubrication, debris free parts
•
Tool change flexibility (clamp frame)
•
Perimetral scrap: 10 mm
•
Warm-up automatic cycles for production start
•
Fully automatic cycle with all process parameters storage
(incl. “soft” proportional vacuum, mold release, sag control, bubble)
•
Self-diagnostic with real-time alarms shown on OP
•
Auto-learning features (Cannon dedicated software)
•
Fast adjustable clamp frame
•
Plug assist
•
Sag control function and pre-blowing
•
Motorized mould carrier table moving (OPTION)
•
Motorized mould carrier (OPTION)
•
Adjustable plates (OPTION)
CREA®
TECHNICAL DATA
CREA 0805-03
CREA 1007-04
750 x 500 x 300 mm
1000 x 700 x 450 mm
Upper heater ceramics heating element
125 x 60 mm
125 x 60 mm
Lower heater ceramics heating element
250 x 60 mm
250 x 60 mm
Heaters control on the 2 Siemens panel
In single
In single
Upper element installed power
9,75 kw
18,2 kw
Lower element installed power
4,8 kw
11,2 kw
Mould max. height (basement included)
350 mm
450 mm
Max. height plateup
200 mm
300 mm
Cooling fans
Vacuum pump capacity
2
3
4
3
m /h 45
m /h 45
lt. 500
lt. 500
touch screen
touch screen
19,4 kw
35,9 kw
Machine width
1,8 m
2,2 m
Machine length
1,7 m
2,2 m
Machine height with plateup
3,2 m
3,6 m
proportional valves
proportional valves
Tank capacity
Siemens operator panel
Total power installed
Storage process control (“soft” vacuum, floating
deep-drawing) - OPTION
TECHNOLOGICAL PLATFORM
Detail of the upper part of the machine
where all the mechanical parts and the
transmission devices of the self-lubricating
platens are placed (clamp frame, upper
plate, mould carrier platen).
The mould box, free from these components, allows easier clearing and spotless
moulds so that on the thermoformed part
no debris lays down damaging the part
itself.
CREA - THF11_EN Cannon Communication 05/2013 EB/ED
Forming Area