Desert Cube Daily Cleaning Procedures trough urinalS

Deser t Cube Daily Cleaning Procedures
Trough Urinals
In a desert environment saving water is easy if you know how. The Desert Cube Waterless
urinal technology uses a series of microbial cubes that slowly dissolve over several weeks
triggering the release of beneficial microbes. This results in a natural breakdown of
organic matter inside the drain which interferes with the bacterial digestion that produces
unpleasant odours.
Step
1
Step
2
Wet the urinal with cold water using the watering
can or hose provided.
Use 4 litres of water per 60cm of trough.
Step
3
Scrub the entire urinal surface with the brush
provided or an optional long handle model. Pay
special attention to the step in front of the urinal,
below the front edge of the urinal and drain hole.
You must remove all marks and stains.
Step
4
Rinse again with cold water using the
watering can or hose provided.
Use 4 litres of water per 60cm of trough. After
rinsing, pour 8 litres of water directly into the drain.
Spray down the whole area including floor
and surrounding tiles with pre-diluted Desert
Washroom Cleaner at the ratio of 10ml to 750ml
of water. Do not rinse after spraying.
Place 1 cube for every 60cm of urinal trough. Place
cubes at the back wall of all urinals. Only replace
cubes once they have completely dissolved.
Do not: Use a mop or empty the mop bucket on the urinal.
Do not: Use any other chemicals in the urinal.
Do not: Use hot water on the urinal.
w w w. d e s e r t . c o m . a u - 1 3 0 0 7 2 1 8 2 5
Deser t Cube Daily Cleaning Procedures
Porcelain Urinals
In a desert environment saving water is easy if you know how. The Desert Cube Waterless
urinal technology uses a series of microbial cubes that slowly dissolve over several weeks
triggering the release of beneficial microbes. This results in a natural breakdown of
organic matter inside the drain which interferes with the bacterial digestion that produces
unpleasant odours.
Step
1
Step
2
Wet the urinal with cold water using the watering
can or hose provided.
Use 4 litres of water per porcelain urinal.
Step
3
S crub the entire urinal surface with the brush
provided. Pay special attention to the tiles below
the urinal, under the front edge of the urinal
and drain hole.
You must remove all marks and stains.
Step
4
Rinse again with cold water using the watering can
or hose provided.
Use 4 litres of water per porcelain urinal.
Spray down the whole area including floor
and surrounding tiles with pre-diluted Desert
Washroom Cleaner at the ratio of 10ml to 750ml
of water. Do not rinse after spraying.
Place 1 cube in each porcelain urinal. Place cubes at
the back wall of the urinal. Only replace cubes once
they have completely dissolved.
Do not: Use a mop or empty the mop bucket on the urinal.
Do not: Use any other chemicals in the urinal.
Do not: Use hot water on the urinal.
w w w. d e s e r t . c o m . a u - 1 3 0 0 7 2 1 8 2 5