GUIDANCE LIGHTBAR

GUIDANCE LIGHTBAR
QUICK START INSTRUCTIONS
KIT CONNECTION.
GENERAL PF SETUP
PORTS SETUP
TOP PORT
GPS On l y
Check the user manual VISION DPB or VISION WPB,
chapter “information and Ports setup”
Integrated guidance bar
Power button
USB port with rubber cover
Backlit touch screen
The following instructions are provided to enable you to
quickly start using this equipment via the two main menus:
• ACCUEIL (HOME)
• CONFIGURATION
ALSO REFER TO THE MANUFACTURER’S INSTRUCTION MANUAL.
Réf: 400 521 - 00 -
GB /DIS
1
Á Switch on the console.
C O N F I G U R AT I O N
V E H I C L E S ET TI N GS
Á Use
Á Press
and
to adjust the settings.
to go back to the Configuration menu.
2
TOOL SETTINGS
Á Use
and
the settings.
Á Press
to adjust
to go to the next
settings.
Á Press
to go back to the
Configuration menu.
ACCUEIL (HOME)
Á Press
and select the tasks in the order
indicated.
3
S P R EAD I N G S ET TI N GS
Á Select the status bar
Á Select the guidance mode
Á Ideally, select the straight line guidance mode
.
Á Press
to go back to the status bar.
Á Check the status of
auto mode enabled.
auto mode disabled.
Á Switch between modes by pressing
4
S PR E ADI N G
Á Enable the field outline
Á Start spreading around the
edge of the field.
Á While spreading in a straight
line, place point
Point
will remain disabled
until you have travelled 40 m
Point
is now enabled
Á Place point
Á The guidance line appears
Á Outline completed.
Á Save the surface area to be treated.
5
S P R EAD I N G (C O N TI N U E D )
Á Continue spreading,
following the LEDs
on the guidance bar.
Á Once you have finished spreading, press
Save your work
Retrieve your saved tasks in the
CONFIGURATION settings
Á Press
then “Job Data”.
Á To transfer your data onto a
USB stick, select the job
then use the arrows to move
it onto the USB stick
6