SULLY`S TAVERN BR5850 LED Control LED Lighting Circuit Board

SULLY’S TAVERN
BR5850
Sully’s Tavern has two interior LED lights (white). The Circuit Board is located on the rear interior wall
and accessed from underneath the building.
LED Lighting Circuit Board
(C) 2 Dimmer Controls
Lead Cable plugs into Port
(A). Lights plug into Ports
(B). Above each LED Port is
16–20VAC
the corresponding dimmer
control (C). Use a small
slotted or Phillips head
Power
screwdriver to adjust light Port
(A)
brightness.
D1
C1
Dimmer
Controls (C)
+
(B) 2 LED Ports Maximum
current 30mA each
_
(A) 1 Power Port 16-20VAC
power source required
LED Control
CONN1
CONN2
CONN3
CONN4
LED
Ports (B)
OPTIONS FOR LIGHTING YOUR BUILDING
Model Railroad Transformer/Power Pack
Connect wires on Lead Cable to the accessories terminals on train transformer/power pack.
When a longer cable is needed, use 24AWG cable (not included). Connect wires on Lead Cable to
wires on 24AWG cable with electrical tape or wire connectors.
Just Plug™ Power Supply (JP5770) Purchase at woodlandscenics.com.
Unplug Lead Cable and insert Power Supply Plug into Port (A). Plug Power Supply Transformer
into an electrical outlet.
See the complete Lighting System at woodlandscenics.com
Instructions for using
Just Plug™ Lighting System
with Lighted O Scale Buildings
PROVIDE POWER TO A LIGHTED O SCALE BUILT-&-READY STRUCTURE
®
Use a Just Plug Power Supply (JP5770).
Fig. 1
Fig. 2
BUILT-&-READY CIRCUIT BOARD
POWER
SUPPLY
DIMMER
CONTROLS (C)
POWER
PORT (A)
CIRCUIT BOARD
LEAD CABLE
CIRCUIT BOARD
LED PORTS (B)
•Unplug Lead Cable from Power Port (A) on
the Built-&-Ready circuit board (Fig. 1).
•Insert Power Supply plug into Power Port (A) (Fig. 2).
CONNECT A LIGHTED O SCALE BUILT-&-READY STRUCTURE TO OTHER
BUILDINGS USING THE JUST PLUG™ LIGHTING SYSTEM
®
Just Plug Power Supply (JP5770), Light Hub (JP5701) and Connecting Cable (JP5760) required.
Fig. 4
Fig. 3
CONNECTING
CABLE
POWER SUPPLY
CIRCUIT BOARD
CONNECTING
CABLE
LIGHT PORTS
•Unplug Lead Cable from Power Port (A) on the
Built-&-Ready circuit board (Fig. 1).
•Insert plug of a Connecting Cable (JP5760) into
Power Port (A) on the circuit board (Fig. 3)
CIRCUIT BOARD
•Insert plug on other end of Connecting Cable into a LIGHT
Port on the powered Light Hub (Fig. 4).
WOODLAND SCENICS
PO Box 98, Linn Creek, MO 65052
woodlandscenics.com
®