Flex Pt Flyer.pub (Read-Only)

P L A T I N U M
The FlexECUTM Pt has been specifically developed as a
UAV customized addition to Orbital’s FlexECUTM family.
This compact and light weight unit is field proven on UAV
applications, delivering on all UAV specific requirements with the ruggedness and
reliability of a high volume automotive production ECU. The FlexECUTM Pt interfaces with
common UAV flight management system architectures and includes support for fly-bywire through servo motor throttle control.
The FlexECUTM Pt is suited to direct injection single-cylinder or two-cylinder boxer engine
applications.
DIGITAL SUBSYSTEMS
•
•
•
•
•
POWER SUPPLIES
Automotive grade Infineon XC27XX
microcontroller
144-pins, 66MHz, 50kb RAM, 768kb Flash
64kbyte NVRAM for calibration development
64kkB Serial EEPROM for adaption and
diagnostic value storage
100% authentic electronic components
•
•
•
•
INPUTS
COMMUNICATIONS
•
•
•
•
•
1x CAN transceiver for calibration and
vehicle networking
Full support for CAN Calibration Protocol
(CCP)
Full support for J1939 CAN protocol
Compatible with Etas’s INCA calibration
software and hardware
Fully supported by the Orbital Diagnostic
Tool
•
•
•
•
•
•
•
ENCLOSURE
•
•
•
•
•
Operates on 6V-16V supply, nominal 12V
Over-voltage and transient spike protection
2x Isolated, high-precision voltage regulators
for powering external sensors
2x Isolated, switch-mode voltage regulators
for powering servos (1.5A each)
Variable reluctance or Hall-effect crank
sensor input
4x 0V-5V analog inputs
3x temperature sensor inputs
1x digital/frequency inputs
Onboard barometric pressure sensor
Angle-based manifold pressure sampling
capability
Redundant throttle position sensor capability
OUTPUTS
66-pin Deutsch Autosport connector
(MIL
-C-38999 Series 1.5), IP67 when mated
Light weight pressed aluminium enclosure
designed for EMC
Compatible with high performance EMC
engine harnesses
Customized housing designs available
Enclosure dimensions: 104mm x 138mm x
25mm
•
•
•
•
•
2x switch-mode drivers for low-impedance
injectors (includes air injectors)
2x saturation injector drivers for highimpedance fuel injectors
4x general-purpose low-side drivers
2x servo motor drivers
1x push-pull output for transistorized ignition
coil
Specifications not meet your requirement? Talk to us
about or rapid turn around ECU customization service.
Orbital Australia Pty Ltd ▪ T: 61 (08) 9441 2311 ▪ F: 61 (08) 9441 2133 ▪ E: [email protected] ▪ W: www.orbitalcorp.com.au