Pro Level Installation

Pro Level Installation
t i l e s h o p. c o m
Pro Level Installation
1. SUBFLOOR
Clean & sweep the
floor.
Tape seams and silicone
cracks or holes in plywood
4. fill
2. door ways Install pieces of
wood in doorways to “damn”
the self leveler when it is poured,
silicone the edges of the wood to
hold them place.
3. Vents
5. Prime Use PRO PRIMER to prime
subfloor using roller or brush. Allow at
least 1 hour between coats
6. mesh Staple either platic or wire
lath to subfloor. Overlap each seem
about 3 inches.
It is recommended to use two coats of
primer.
Layout the mesh
perpendicular to any seams in the
floor.
7. Layout
Pour water from
premeausred bucket into 6 gallon
pail.
8. water
Cover and silicone all floor
vents.
Use plastic when you are also
installing in-floor heat.
Add PRO LEVEL
powder to clean measured water.
9. pro level
G et i n spire d at t i l e s h o p. c o m
Use a mixer bar to mix
PRO LEVEL for 2 minutes.
10. mix
11. Pour
Pour your mix into the
space.
Keep pouring until
your entire space is filled and level.
12. continue
You have 10 minutes between every
pour.
OTHER HELPFUL HINTS :
-- Do not add heat to speed the cure time.
-- Do not use a fan to speed cure time.
-- Do not use warm water when mixing.
-- Be sure the primer is completely dry before the leveler is poured.
13.dry Allow PRO LEVEL to dry for
24 hours undisturbed.
NEXT SET THE TILE : SEE THE HOW
TO FLOOR TILE GUIDE FOR MORE
INFORMATION
Pro Level Installation Checklist
348317 Pro caulk gun
348310 rubber gloves
066860 wire lath
066861 pro plastic lash
347969 mixer bar
043518 pro level
347811 meausring pails
347811 6 gallon pails
347811 pro primer
026011 clear silicone
G et i n spire d at t i l e s h o p. c o m