SoftGate® Valve Pin Velocity Control



SoftGate® Valve Pin Velocity Control
SoftGate® Valve Pin
Velocity Control
IAdvanced Sequential Molding Performance
New Technology
SoftGate® Valve Pin Velocity Control
I Advanced Sequential Molding Performance
The INCOE® SoftGate® system is an enhanced feature that precisely controls the opening phase of the
hydraulic valve pin. This allows for the “gradual and controlled” flow of plastic into the cavity reducing
or eliminating the negative effects of blemishes, and weld
lines that can occur with uncontrolled plastic flow.
a) Control module in the hydraulic circuit
b) Valve pin and tip insert
c) Valve pin position
d) Timer for recording pin open time
I Precise control of valve pin opening time
I Each valve independently adjustable
I Valve pin velocity control for hydraulic valve gate systems
I Adaptable to DF Gold 12, 18, 22 and 25 series
I Controlled plastic flow at each gate
I Reduced pressure peaks during valve gate opening
I Prevent hesitation marks during sequential injection molding
I High-quality molding surfaces
I Easily retrofitted to your existing INCOE® hydraulic valve gate system
I Simple operation
Global Sales, Service & Support
INCOE® Corporation
‘Schematic and/or altered depiction, errors and omission excepted.
© 2011 INCOE® Corporation EN-03/2012
ISO Certified visit
1740 East Maple Road
Troy, Michigan 48083 USA
T: +1 (248) 616-0220
F: +1 (248) 616-0225
E: [email protected]