Bandana Bib Designed by Tracy Henwood of Desert Rose Designs included

Transcription

Bandana Bib Designed by Tracy Henwood of Desert Rose Designs included
Bandana Bib
Designed by Tracy Henwood of Desert Rose Designs
1cm seam allowance
included
Page 1 of two
1cm seam allowance included.
Pattern Instructions:
Cut both pattern pieces out and match at the
match point marked on part A and B. Sticky
tape together.
Cutting Instructions
Place pattern on fold of fabric and cut one piece
from outer fabric. A printed cotton works well.
Cut one from a backing fabric such as flannel or
terry. An absorbant fabric is best.
Sewing.
Place the right sides together and sew with a 1
cm seam allowance all the way around. Leaving
a gap for turning where indicated on pattern.
Trim and clip curves and points.
Turn Bib through opening left.
Topstitch close to the edge of the bib to close
the opening used for turning.
Appy a snap or velcro to the rounded ends as a
closure.