Document 6514625

Comments

Transcription

Document 6514625
 Manual
How to Programme your remote control
BENINCA TWV - BENINCA Cupido - PRASTEL MPSTL2 - CASIT ERTS21RB CASIT MT4E - ALLMATIC Broover
How to program your new remote control:
There are several methods for programming your new remote control.
Please note: if you keep the programming button of your receiver pressed down too long, you will erase the
programming code of all of your remote controls that have already been programmed
•
From the receiver:
1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board, press the programming button (PGM). The LED light of the receiver illuminates. Let the button go.
3. In the next 10 seconds, press a button on your new remote control. Let it go.
4. Wait 10 seconds.
5. Your new remote control is programmed.
•
From a remote control that has already been programmed:
1. With a sharply pointed object, press the hidden button on the back of your already-programmed remote control or press the hidden
button found next to the battery in the inside of your remote control (fig 1). Let it go.
2. The LED light of your already-programmed remote control illuminates. Wait 5 seconds. The LED light of your already-programmed remote
control turns off.
3. During the next 10 seconds, press a button on your new remote control. Let it go.
4. Wait 10 seconds.
5. Your new remote control is programmed.
www.AlloRemoteControl.com 

Similar documents

Hotmail Technical Support New Zealand Helpline Number +64-92-805567

Hotmail Technical Support New Zealand Helpline Number +64-92-805567 Hotmail Support New Zealand, the company renowned for its high-quality expert support on the problems regarding the operation of Hotmail or outlook account is now providing its services 24*7. For more information please visit us:- http://hotmailsupport.co.nz/

More information