Cable Source Media Router User Guide Version 4.3.3 SMR-C45 and SMR-C48

Transcription

Cable Source Media Router User Guide Version 4.3.3 SMR-C45 and SMR-C48
Cable Source Media Router
Version 4.3.3
User Guide
SMR-C45 and SMR-C48
Software Release 4.3.3
Document Number 112-0060-02
SMR-C45 and SMR-C48 Version 4.3.3 User Guide
About this User Guide
This User Guide introduces the SkyStream Source Media Router (SMR) and
provides procedures for operating these systems. See the Quick Start Guide for a
detailed step-by-step account on how to start and configure your SMR.
How this Guide is
Organized
This guide consists of the following chapters:
Chapter 1
Overview
Introduces the SMR-C45 and SMR-C48
Chapter 2
Basic Concepts
Explains SMR basic concepts
Chapter 3
User Interface
Reviews the SMR user interface and navigation methods
Chapter 4
Configuring Agents
Outlines how to configure the agents that communicate with external
servers
Chapter 5
Configuring Ports
Provides information on how to configure the SMR’s ports
Chapter 6
SkyPilot System Information Device
Provides information on creating Services and Program Elements for
PSI/SI tables
Chapter 7
Error Scenarios
Describes how to handle possible SMR error scenarios
Appendix A Hardware and Cables
Lists SMR hardware specifications, proprietary cable pin-outs and
port descriptions
Appendix B Troubleshooting
Describes how to monitor the SMR
Appendix C Packet Formats
Describes the method that the SMR uses to partition MPEG-2
packets
Appendix D IP Forwarding Command Files
Contains information on modes of operation and syntax required for
creating command line files
Appendix E Simple Network Management Protocol Describes the usage of SNMP for monitoring the SMR
Appendix F Backup/ Restore Ghost Image
Describes creating and restoring a backup image for the SMR using
Ghost software utility
Appendix G Common Alarms
Provides a list of Fatal alarm messages
Glossary
Acronyms, Abbr. and Definitions
Defines or identifies terms, abbreviations and acronyms as they are
used in this guide
Forms
Bug Reports
Contains a form and checklist for reporting bugs.
Who Should Read
this Guide
You should read this guide if you are an SMR operator, an installation planner or a
manager who wants to review SMR characteristics, features and procedures.
7
Table of Contents
Table of Contents
Chapter 1: Overview of Cable
Source Media Router . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
SMR-C48 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .18
SMR-C45 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20
System-specific Terminology . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21
Systems Interacting with the SMR-C45 and SMR-C48 . . . . . . . . . . . . . . . 21
Chapter 2: Basic Concepts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
Data Injection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .24
Ports and Packetizers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25
MPEG-2 Transport Stream Packets . . . . . . . . . . . . . . . . . . . . . . .26
MPEG Sections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
Packetizing Sections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
Matrix of Allowed Logical Ports and Packetizers . . . . . . . . . . . .27
Using IP Based Protocols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .28
When do you use Ethernet IP Forwarding? . . . . . . . . . . . . . . . . . . . . . . . . 28
How to Select Between TCP and UDP? . . . . . . . . . . . . . . . . . . . . . . . . . . . 29
Advanced Bandwidth Management . . . . . . . . . . . . . . . . . . . . . . .31
Redundancy . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .32
Automatic Redundancy . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
Manual Redundancy . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
Protection Scenarios . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35
Bypass Capability . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .37
SMPTE 325M—Flow Control . . . . . . . . . . . . . . . . . . . . . . . . . . . .38
Multiple Inputs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .39
Multiple TSIO Inputs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
PID Filtering . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .40
PID Mapping . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .42
PID Assignment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
Stream Merging . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .44
SI Parsing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .45
Chapter 3: User Interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47
9
SMR-C45 and SMR-C48 Version 4.3.3 User Guide
Chapter 1: Overview of Cable
Source Media Router
17
SkyStream Networks
SMR-C48
The SkyStream SMR-C48 Cable Source Media Router is a data encapsulator that
receives IP, MPEG, or other data through a File In, UDP In, TCP In, or
Ethernet IP Forwarding In logical port. The SMR-C48 sends data out as an
MPEG-2 Transport Stream through the Transport Stream In/Out (TSIO) Out
port.
SMR-C48 Description of System Functionality
Data Piping A packetizer used
for encapsulating either a
proprietary byte protocol or
synchronous bit stream.
The SMR-C48 creates a DVB-compliant MPEG-2 Transport Stream for data
over satellite services.
Industry-leading Performance
■
MPE (Multi-protocol
Encapsulation) DVB
packetization format that enables
a high-speed gateway to an
asymmetric Internet (or private
IP-based) network by
retransmitting IP information in
addition to the payload.
■
High data rate support, up to 48 Mbps over complete (8191) DVB PID range
Supports up to 256-QAM capacities
Reliable Operations
■
High availability platform for strict service uptimes
■
1:1 system redundancy with optional automatic redundancy switch
■
No hard disk—all software runs from flash card, resulting in fewer moving parts
Simple Manageability
■
■
18
Network-based graphical real-time control (SkyPilot) and monitoring (SkyAlarm)
applications
SNMP v1, v2c and v3 (security) enabled
Overview of Cable Source Media Router
SMR-C45 and SMR-C48 Version 4.3.3 User Guide
Backup/Restore Ghost Image
Set Up Control PC
Prior to starting this procedure, the following steps must be performed on the
control PC (or whichever Windows platform you will use to handle the CD and
store the images):
1 Note down the IP address, system name, and workgroup of the control PC.
2 Share the C: drive of the control PC.
If restoring to the factory image, also perform the following steps:
3 Copy all files in the SMR NT folder (includes SMR431NT.GHO (or similar)
and the application GHOST.EXE) from the SkyStream software CD into the
C:\ folder. Files must be stored in the root C: directory.
4 Save a copy of the hgt.twk file located on the SMR at C:\Winnt\system32
onto the control PC.
Create a Backup of
the SMR
Creating a backup image of the SMR assumes that the SMR has been properly
configured specifically for a user’s application. This image can be created and
stored on any Windows PC (for example, the control PC).
NOTE This procedure should be performed whenever the SMR configuration
has changed significantly.
1 Copy ghost.exe from the SkyStream software CD into the C:\folder on the
control PC. Ensure that there is at least 90 MB of free space on the C:\ folder
of the control PC.
2 Reboot the SMR.
3 Hold down the down-arrow key at the DOS screen when the “Verifying DMI
Pool Data” line appears until the option “Please select the operating system to
start” appears.
4 At “Please Select the operating system to start,” choose DOS.
5 At “MS-DOS 6.22 start up menu,” select “Start SMR with Network support,”
choice 1.
6 Edit the C:\Protocol.ini file for the following parameters:
NOTE This does not affect the IP address of the SMR when booted into NT.
■
Default Gateway
■
IP Address
■
Subnet Mask
7 ALT-F will display file menu. Select Save and Exit.
8 Edit the C:\ SYSTEM.ini file for the following parameter: Workgroup
313
SkyStream Networks
Fatal Alarms
This section describes fatal alarms which are displayed in the SkyAlarm “Event
View”. These fatal alarms are also sent out as SNMP traps.
Health Agent
Alarms
MESSAGE ID:
MESSAGE DESCRIPTION:
PARAMETERS:
SEVERITY LEVEL:
REASON:
MESSAGE ID:
MESSAGE DESCRIPTION:
PARAMETERS:
SEVERITY LEVEL:
REASON:
MESSAGE ID:
MESSAGE DESCRIPTION:
PARAMETERS:
SEVERITY LEVEL:
REASON:
MESSAGE ID:
MESSAGE DESCRIPTION:
PARAMETERS:
SEVERITY LEVEL:
REASON:
320
57377 (No Response From Carousel Agent)
No response received from Carousel Agent on <> – this machine may need to
be rebooted.
SMR hostname
Fatal
The Health Agent did not receive a health check response from the Carousel
Agent.
57381 (No Response From SkyLocal)
No response received from SkyLocal on <> – this machine may need to be
rebooted.
SMR hostname
Fatal
The Health Agent did not receive a health check response from SkyLocal.
57393 (No Response From SkyNet)
No response received from SkyNet on <> - this machine may need to be
rebooted.
SMR hostname
Fatal
The Health Agent did not receive a health check response from SkyNet.
57477 (SkyNet Not Responding)
Tripped the watchdog because SkyNet is not responding
None
Fatal
The Health Agent has tripped the watchdog because it did not receive a “health
check” response from SkyNet. This alarm will occur only if “Switch on SkyNet
failure” is selected on the Health Agent’s properties page.
Common Alarms