Slab Doors - HD Supply

Transcription

Slab Doors - HD Supply
Fabrication Form — Slab Doors
FAX COMPLETED ORDER FORM TO 1-866-455-8903 OR EMAIL TO [email protected]
REQUEST TYPE: q Order q Quote
SHIP TO (Property Name)
ACCOUNT NUMBER
ORDER DATE
PURCHASER NAME
PO NUMBER
SHIPPING ADDRESS
CITYPHONE
STATEZIP
SALES REP NAME
SOURCE CODE:
SALES REP PHONE NUMBER
FAX ORDER CONFIRMATION TO:
NAME:
FAX #:
SLAB DOOR
INFORMATION
INFORMATION
HDS PART NUMBER
QTY
Door Style
Core Type
q Flush Primed White
q Hollow
Size:
q 3-1/2"
q Flush Lauan
q 6-Panel - Textured - Primed White
q 2-Panel - Smooth - Primed White
q Flush Legacy Tru-Oak*
q Flush New Mendocino*
q Flush Legacy Walnut*
q Other ______________________
q Solid
Thickness
q 4"
q 4-1/2"
q 1-3/8"
q 1-3/4"
Radius:
*Available regionally
Hinges
Strike Plate
q 1 x 2-1/4" (standard)
q Radius Corner (1/4" standard)
q Square
Drive
In
q
COMMENTS
q 1/4"
q 5/8" (standard)
q Square
q Cut Through
INDICATE HINGE, LOCKSET & DEADBOLT LOCATIONS
Door Dimensions
Hinge Placement
Lockset Placement
Deadbolt Placement
Door Width
Peephole
Door Height
❑ 2-3/8"
❑ 2-3/4"
❑ 2-3/8"
❑ 2-3/4"
Deadbolt
Backset
Lockset
Backset
1. All measurements must be in inches. Hinges and lockset location
measurement must be taken from the top of the door.
2. Measure both sides of the door. Use the larger of the two dimensions.
3. Provide measurements to the nearest 1/16".
4. Actual door size is 3/16" shorter in width, however, if actual size is needed, please note.
5. All lock bores will have a standard 2-1/8" diameter.
6. All latch bores will have a standard 1" diameter.
7. If door is cut more than 1" in height, it must be rerailed.
Handing
❑
❑
Left Hand
Right Hand
LH Swing
RH Swing
SLAB DOOR ORDER TERMS
Due to custom requirements and lead times, slab door orders may not be cancelled and slab doors are not returnable. Any
additional charges for changing sizes or quantities after the initial order is placed will require a new worksheet, and an additional invoice
will be created. By signing below, you agree to the terms stated above.
ACCEPTED BY:
DATE:
Phone 1-866-455-8907
FRM-14-10383_2014 Writeable PDF Fabrication Forms_R2.indd 1
Fax 1-866-455-8903
[email protected]
FAB 00/14
Please check all measurements shown above before signing this order form.
11/21/14 12:02 PM