Data Sheet - Shalimar Paints Industrial Business

Transcription

Data Sheet - Shalimar Paints Industrial Business
MARINEGUARD
PROTECTIVE COATINGS
SHALILAC SYNTHETIC ENAMEL
Top quality high gloss enamel based on synthetic resin vehicle and stable weather resistant pigments. It is
designed for both protection and decoration, internally as well as externally, for areas above water. It has good
application properties and flow, and it dries in a short duration to give a smooth surface.
Product Information
Surface Preparation
Type
Top Quality Alkyd resin based
Synthetic Enamel.
Finish
Smooth & Full glossy
Flash Point
Above 30˚C
Mixing Ratio
Base : Accelerator 1 : 1
Volume Solids
34% + / - 1
Recommended
primers
Metal - Shalimar Red Zinc
Chromate Primer.
Corresponding wet
film thickness
149 - 224 microns per coat
Theoretical
Spreading Rate
Method of Application:
Brush / Spraying
Airless spray recommended for uniform and high
film build.
6.8 – 2.8 Sq.metre per litre
Average Spreading -
Drying time
Surface dry - 4 - 6 hours
Hard Dry
- 8 - 10 hours approx.
microns dft.)
There should be no objectionable
skinning, colour floatation,
considerable medium separation,
pigment settling.
Thinner:
Condition in
container
Dry Heat Resistance
Upto 150˚C (intermittent)
Storage life
1 year
STEEL SURFACES:
The surface to be painted should be dry and free
from dust, rust, oil and loose matters. After
application of suitable primer two coats have to
be applied at an interval of 10 – 12 hours between
coats.
Application Details
13.6 - 11.3 sq.m/Lt./Coat
Capatity (at 25-30
Notes on Airless Spray:
6751
Shalimar Paints Ltd.: 4th Floor, Plot No. 64, Sector-44
Gurgaon -122001, Haryana (India) | P: +91-124-4616600 | F: +91-124-4616659
E: [email protected] | www.shalimarpaints.com
DISCLAIMER: The information in this leaflet is given in good faith. The company will not be liable for loss or damage howsoever caused
including liability for negligence, which may be suffered by the user of the data contained therein. It is the user's responsibility to conduct
all necessary tests to confirm the suitability of any product or system for their intended use. No guarantee of result is extended since
conditions of use are beyond our control.
1