ma gnetic sensors for cylinders
Transcription
ma gnetic sensors for cylinders
MAGNETIC SENSORS FOR CYLINDERS Magneto-Resistive Sensors “SHP-6T” SERIES The Aeco Magneto-Resistive sensors SHP series are particularly suitable for applica tions where is needed know the exact shaft positioning of a pneumatic cylinder . To achieve this information the magnetic field generated by the permanent magnet in the cylinder is detected by means of a sensor fixed externally in the T slot. When the magnet approaches the sensor a sensible component to the magnetic field contained in its electronics controls that a given value is reached. When reaching such value the LED indicator and the sensor output activate signaling the final cylinder shaft position. Fixing Screw Cable Led Ø3 6.2 4.2 ~ 2000 31 SHP-6T PNP NO Fixing Screw M8 male connector Mobile metal ring Cable Led M8x1 Ø3 6.2 38.0 4.2 340 31 Dimensions mm TECNICHAL CHARACTERISTICS Response sensitivity Continuous voltage (res. ripple <10%) SHP-6T PNP NO LC0.3 M8 SHP-6T PNP NO SHP-6T PNP NO LC0.3 M8 SEH000012 SEH000011 mT < 2.8 V 10 ÷ 30 ms <2 Hz 5000 Hysteresis mT < 20% Repeatability mT < 0.1 Max output current mA 100 mA V < 12 Time delay before availability Switching frequency Absorption at 24 Vdc Voltage drop (sensor ON) < 1.8 Short circuit protection INCORPORATED Led INCORPORATED Temperature limits °C -25 ÷ +75 IP rating IP 67 Housing PLASTIC PVC cable 0.3m PVC cable 2m WIRING DIAGRAMS 4 1 - 3 x 0.14 mm² + CONN. H1 - 3 x 0.094 mm² INSTRUCTIONS FOR CORRECT INSTALLATION VIEW OF MALE CONNECTOR H1 3 1 = Brown / + 3 = Blue / 4 = Black / output PNP NO Insert sensor Turn sensor Tighten screw LED BROWN BLACK PNP NO BLUE ETC000393 CH003B - 11/11 S.r.l. via G. Leopardi, 5 20065 Inzago (MI) Italy - Tel. 0295438.1 (5 linee r.a.) Fax 029548528 http://www.aecosensors.com E-mail: [email protected] MAGNETIC SENSORS “SEM-6T..” SERIES Dimensions mm Cable Led Fixing Screw Ø3 6.2 SEM-6T NO 4.2 ~ 2000 31 Cable Led Fixing Screw M8 MALE CONNECTOR MOBILE METAL RING M8 Ø3 6.2 SEM-6T NO LC0.3 M8 38.0 4.2 31 TECNICHAL CHARACTERISTICS Response sensitivity 340 SEM-6T NO SEM-6T NO LC0.3 M8 SEM000001 SEM000002 mT <3 V 10V DC ÷ 250V AC/DC Continuous voltage (res. ripple <10%) Max. output current 40mA / 250V 100mA / 100V Max. switching power Voltage drop (sensor ON) W/VA V < 2.7 Max. switching frequency Hz 200 mT < 20% Hysteresis Repeatability 10 mT < 0.1 (at 25°C) Sensing point CENTER OF THE SENSOR Short circuit protection NOT INCORPORATED Led INCORPORATED Temperature limits °C -25 ÷ +75 IP rating IP 67 Housing PLASTIC PVC cable 2 x 0.14 mm² 2m 0.3m PUR cable 2 x 0.14 mm² + CONN. H1 WIRING DIAGRAMS SWITCHING DIAGRAM BROWN +/~ V DC/AC LOAD BLUE NO - /~ V Insert sensor 250 Tighten screw Turn sensor 200 150 4 1 INSTRUCTIONS FOR THE INSTALLATION 3 1= 4 = Output VIEW OF MALE CONNECTOR H1 ETC000408 75 0 0 25 50 75 100 mA CM084B - 11/11 S.r.l. via G. Leopardi, 5 20065 Inzago (MI) Italy - Tel. 0295438.1 (5 linee r.a.) Fax 029548528 http://www.aecosensors.com E-mail: [email protected] AECO 20065 Inzago (MILANO) ITALY - Via G.Leopardi,5 Tel. ++39 02 954381 - Fax ++39 02 9548528 www.aecosensors.com / email: [email protected]