P2D2A_Datasheet_Pg1_v2 - Rincon Research Corporation
Transcription
P2D2A_Datasheet_Pg1_v2 - Rincon Research Corporation
PACKETS - TO -A NALOG C ONVERTER P2A Wideband. Reconfigurable. Scalable. SDDS data inputs via 10G interfaces L-Band analog output (950–1750 MHz) 1800 MSPS 14-bit dual channel D/A converter 6 Channel output per D/A 4 40 MHz BW streams 2 80 MHz BW streams 1.5 GB DDR memory per D/A channel Allows absorption of large network latency Independent configuration for each input stream Programmable attenuator (31.5dB, 0.5dB Steps) Accepts external 10 MHz reference (optional) Command/Control via dedicated Ethernet interface Redundant, hot-swappable power supplies RINCON RESEARCH CORPORATION’S P2A FAMILY BUILDS UPON THE P2A’S LARGE NETWORK BUFFER FEATURE provides A DECADE of uninterrupted data playback even with large network latency. experience fielding wideband RF systems. The P2A uses multi-rate signal processing techniques to combine The configurable network buffer also enables the P2A to up to 6 SDDS packet streams into a single generate long periods of continuous data even with frequency-multiplexed D/A output. non-coherent reference clocks. The compact 19-inch rackmount (1U) chassis contains the RF components required for connecting directly to L-Band analog modems, block upconverters, or a signal distribution infrastructure. The integrated high-performance cavity filter provides a spectrally-clean L-Band output from 950 MHz to BUILT UPON HIGH-PERFORMANCE FPGA TECHNOLOGY, the P2A supports seamless in-field firmware upgrades to meet the demands of evolving requirements. Our scalable solution makes it easy to deploy and maintain hundreds of units. 1750 MHz. OUTPUT SPECTRUM The 10 G Ethernet SDDS inputs feed a flexible de-packetizer 40 MHz Bandwidth 80 MHz Bandwidth that can be configured to receive multicast or unicast data from multiple sources across multiple VLANs. The P2A supports both 40 and 80 MHz bandwidth signals. 900 MHz ADDRESS 101 N. Wilmot Rd., Ste. 101 Tucson, Arizona 85711 ORDER LINE 520.519.3131 [email protected] 1000 MHz 1100 MHz 1200 MHz 1300 MHz 1500 MHz TECH SUPPORT 520.519.3132 [email protected] INFORMATION SUBJECT TO CHANGE WITHOUT NOTICE ▪ PRODUCTS ARE SUBJECT TO THE RESTRICTIONS OF THE ARMS EXPORT CONTROL ACT 1700 MHz 1800 MHz FAX | WEB 520.519.3120 www.rincon.com ▪ V 1.2 SYSTEM: P2A DSPBrik II – X7D2285-X330C1 1.5 GB Buffer 10 GbE SFP+ Six-Stream Depacketizer Sub-Band Combiner (x6) 40 MHz (x4) 80 MHz (x2) DAC O L-Band Filter + Amp 10 GbE SFP+ Six-Stream Depacketizer Sub-Band Combiner (x6) 40 MHz (x4) 80 MHz (x2) DAC 1 L-Band Filter + Amp L-Band 950-1750 MHz L-Band 950-1750 MHz ® 10MHz Virtex 7 VX330T FPGA Timing I/F 1PPS 1.5 GB Buffer IRIG-B GENERAL SPECIFICATIONS AN ALOG OUTPUT SPECIFICATIONS ORDERING INFORMATION Power Connector NEMA5-15 Analog P2A – G D S A – A2P – C P – F B L R Power 110/220VAC 50/60 Hz, 300 Watts (Max) Number of 10 G Ethernet Inputs 1 per D/A, up to 8 Number of D/A Outputs Up to 8 Command/Control 10/100/1000 Ethernet, RJ45 Dimensions 40 MHz: -21 dBm max, 80 MHz: -18 dBm max, 50 ohm, AC coupled, 950-1750 MHz SMA connector Call for availability and custom configurations. P2A G: Number of 10 GbE inputs (One per DAC channel, standard) D: Number of wideband DAC channels (1, 2, 4, 6, or 8) S: Output splitter width per channel (1, 2, 4, or 8) A: Integrated amplifier per channel N: Not present A: Present on all channels Clock/Reference 750mVpp - 2Vpp (1.5dBm - 10dBm) 50 ohm, AC Coupled, sine or square wave, SMA connector 1PPS CMOS compatible 50 ohm, SMA connector A2P IRIG-B: 0.5Vpp 6Vpp, 50 ohm, 1kHz AM, SMA NMEA-0813: RS-232 signal Level, LEMO connector, DB9 adapter supplied F: 10 GbE input media S: Short range fiber, 850 nm L: Long range fiber, 1310 nm C: Direct-attach copper cable, 3 ft. 1U-19” Rack mount x 26” D Time Data Connector Digital Data Format ADDRESS 101 N. Wilmot Rd., Ste. 101 Tucson, Arizona 85711 10G Ethernet, SFP+ modules (included), SR/LR fiber or direct attach copper SDDS, 80 and 40 MHz Bandwidths Standard configuration assumes df/dt = 0. ORDER LINE 520.519.3131 [email protected] C: Number of L-Band ADC inputs P: Number of 10 GbE outputs (0, 1, 2, 4,or 8) B: X7D2285 Boot Mode N: NFS F: Internal flash L: Flash Lock U: Unlocked (write-enabled) flash L: Locked (write-protected) flash R: Rack-mount slides N: no slides 28: 28 inch slides 30: 30 inch slides TECH SUPPORT 520.519.3132 [email protected] INFORMATION SUBJECT TO CHANGE WITHOUT NOTICE ▪ PRODUCTS ARE SUBJECT TO THE RESTRICTIONS OF THE ARMS EXPORT CONTROL ACT FAX | WEB 520.519.3120 www.rincon.com ▪ V 1.2