SmartPropo FMS Workshop von Michael Wirger (Schumi) * hotz

Smartpropo
Written by Torsten
Saturday, 04 October 2008 17:25
SmartPropo FMS Workshop
von Michael Wirger (Schumi)
* [email protected]
Joy Interface for the Line/Mic Input of the soundcard
It has never been cheaper to use FMS with Win2000/XP.
6 Channel and 10 Button support!!!
PPM and PCM support
Very easy solution
All you need is:
- The correct smartpropo
- FutabaPCM + FutabaPPM + JrPCM + JrPPM
1x Connector to your student system
1x 3.5mm mono-jack
1x 10kOhm resistor
1x soldering iron and soldering tin.
2m diode-cable
After we have arranges all components and the heated soldering iron on our workplace
we can start.
At first we strip both ends of the mono cable. This must be done very accurately to make
sure that there is no contact between the leads and the shielding. Then the leads must be
tin-coated.
1/8
Smartpropo
Written by Torsten
Saturday, 04 October 2008 17:25
Now solder the mono jack to the cable in the following way:
-
Lead – inner soldering tag (Tip)
Shielding – outer soldering tag (outer ring)
Now close the housing of the jack-connector
Now we can prepare the plug to the student system of your radio. The layout for
some radio types can be found in the picture below.
2/8
Smartpropo
Written by Torsten
Saturday, 04 October 2008 17:25
close
Atthe
lasthousing
connectofthe
theresistor
plug. between signal and shielding of the plug. Then carefully
system
After
task
everything
bar nearis
the
connected
clock). to your PC, open the sound mixer (can be found in the
Select “Line in – Mute” and then “Options – Properties”
3/8
Smartpropo
Written by Torsten
Saturday, 04 October 2008 17:25
“Line
Now
in” go
or “Micro”
to “Volume
(depending
for > Recording”
on which input
and you
under
will“Show
use). Then
Volume
click
Controls”
“OK”. select
4/8
Smartpropo
Written by Torsten
Saturday, 04 October 2008 17:25
systems,
Audio-Recorder
Nowthe
Put
we
please
slider
will to
find
try
for
display
toout
the
find
ifrecording
your
the
a sufficient
wave
work
volume
form).
was
setting
successful:
to maximum
for yourSwitch
PC.
( this
You
on
can
can
the
vary
use
radio.
for
thedifferent
5/8
Smartpropo
Written by Torsten
Saturday, 04 October 2008 17:25
Now
In
thecopy
register
the winmm.dll
“Controls”into
select
the“Analogue
folder of your
Control”.
FMS and start the FMS.
6/8
Smartpropo
Written by Torsten
Saturday, 04 October 2008 17:25
In the
Go
to “Calibration”
“Properties” you
to calibrate
can see and
if FMS
configure
has loaded
yourthe
radio.
driver (winmm.dll).
Driver loaded ....
7/8
Smartpropo
Written by Torsten
Saturday, 04 October 2008 17:25
The complete use is on your own risk !!
8/8