Overhead Console - The Lincoln Mark VII Club

Overhead Console - The Lincoln Mark VII Club

The Lincoln Mark VII Overhead Console
Published By The Lincoln Mark VII Club
Lincoln Mark VII
Overhead Console
V200709162047
Our Lincoln Mark VIIs come equipped with a standard Finish Panel (overhead
console). This console will have at least a bank of warning indicators such as CHECK
SUSPENSION, HEAD LAMP OUT, REAR LAMP OUT, CHECK (ANTI LOCK)
BRAKES. Originally, the compass and outside temperature displays were optional
equipment. The “little trap door in the middle” is for the stock, Lincoln Garage Door
Opener.
©The Lincoln Mark VII Club. All rights reserved.
1
The Lincoln Mark VII Overhead Console
Published By The Lincoln Mark VII Club
Insert a small blade screwdriver in the slot at the rear of one of the reading lamp
assemblies. This slot will only be 3 to 5 millimeters deep. Push screwdriver rearward
and pull down on lens. Remove LH and RH lens assemblies.
©The Lincoln Mark VII Club. All rights reserved.
2
The Lincoln Mark VII Overhead Console
Published By The Lincoln Mark VII Club
Remove two center finish panel retaining screws.
©The Lincoln Mark VII Club. All rights reserved.
3
The Lincoln Mark VII Overhead Console
Published By The Lincoln Mark VII Club
Pull finish panel down and disconnect all electrical connectors. My map lamp bulbs
were hot enough to fry an egg so DON’T TOUCH EM!
©The Lincoln Mark VII Club. All rights reserved.
4
The Lincoln Mark VII Overhead Console
Published By The Lincoln Mark VII Club
Above the left hand connector, you can see one of our THIRTEEN ground wire
locations.
©The Lincoln Mark VII Club. All rights reserved.
5
The Lincoln Mark VII Overhead Console
Published By The Lincoln Mark VII Club
The 921 map light lamps should not be toughed with bare hands. The oil in our skin
can cook on the surface of this lamp and cause it to shatter. These lamps pull straight
out forward.
©The Lincoln Mark VII Club. All rights reserved.
6
The Lincoln Mark VII Overhead Console
Published By The Lincoln Mark VII Club
Remove two Phillips screws on the sides of the Garage Door Opener cradle assembly.
©The Lincoln Mark VII Club. All rights reserved.
7
The Lincoln Mark VII Overhead Console
Published By The Lincoln Mark VII Club
Twist out power supply for Garage Door Opener Cradle.
©The Lincoln Mark VII Club. All rights reserved.
8
The Lincoln Mark VII Overhead Console
Published By The Lincoln Mark VII Club
Remove two center screws holding the electronic module to the finish panel.
Removing the module will give you access to the moon roof switch (optional).
©The Lincoln Mark VII Club. All rights reserved.
9
The Lincoln Mark VII Overhead Console
Published By The Lincoln Mark VII Club
The four overhead console warning lamps can be replaced by removing the lamp with
integrated socket, by turning them counter clockwise 1/8 turn.
©The Lincoln Mark VII Club. All rights reserved.
10
The Lincoln Mark VII Overhead Console
Published By The Lincoln Mark VII Club
The Outside Temperature and Compass moment switches may sometimes get caught
inside of the overhead console assembly. The switches are loaded with a steel spring.
The spring can be separated from the switch with a small blade screwdriver, releasing
it back into normal operation.
©The Lincoln Mark VII Club. All rights reserved.
11
The Lincoln Mark VII Overhead Console
Published By The Lincoln Mark VII Club
Completely disassembled, the unit looks like this.
©The Lincoln Mark VII Club. All rights reserved.
12
The Lincoln Mark VII Overhead Console
Published By The Lincoln Mark VII Club
Reassembly is in the reverse.
©The Lincoln Mark VII Club. All rights reserved.
13
The Lincoln Mark VII Overhead Console
©The Lincoln Mark VII Club. All rights reserved.
Published By The Lincoln Mark VII Club
14
The Lincoln Mark VII Overhead Console
©The Lincoln Mark VII Club. All rights reserved.
Published By The Lincoln Mark VII Club
15
The Lincoln Mark VII Overhead Console
©The Lincoln Mark VII Club. All rights reserved.
Published By The Lincoln Mark VII Club
16