Full cone - nozzle VI - Hans G. Werner Industrietechnik GmbH

Full cone - nozzle VI - Hans G. Werner Industrietechnik GmbH

YAZGAN Makine ve Gida Ltd. Sti.
distributer of
HANS G. WERNER Industrietechnik GmbH Germany
Type of nozzle: Full cone - nozzles VI
nozzles with pressed in slot spin body and internal thread
characteristics of nozzle
application
material
Full cone spray pattern with
complete wetting of the circular area
with high collision force by special
spraying spin body, very variable
spray angles.
cleaning
washing
process engineering
brass
steel
high-grade steel
plastic
other materials on request
thread
G
ISO 228
dimensions
in mm
full cone
spray pattern
Pic. 1
Pic. 2
Plastic - nozzles can
exhibit other SW
Order example: (Thread type - spray angle - material) 3/8 " - V 19 - 90°- Brass
B = orifice diameter, E = closest cross section, the drillings vary with different spray angles easily
The following spray angles are available: 5°- 15°30°- 45°- 60°- 90°- 120°, other spray angles on request
thread
G = ISO 228
Technical changes pre keep,
conditions 01 January 2007
flow rate V (l/min.) with pressure p (bar)
YAZGAN Makine ve Gida Ltd. Sti. • Kaynarca Cad. 3 • 34906 Sihli / Pendik
Istanbul – Türkiye • Tel.: 0216/3783765 • Fax: 0216/3782861 •[email protected]
chapter: 03
YAZGAN Makine ve Gida Ltd. Sti.
distributer of
HANS G. WERNER Industrietechnik GmbH Germany
Type of nozzle: Full cone - nozzles VI
nozzles with internal thread, large volume stream and pressed in slot spin body
characteristics of nozzle
aoolication
material
Full cone spray pattern with
complete wetting of the circular
area with high collision force by
special slot spin body, very
variable spray angles.
cooling
air and gas scrubber
washing from coal, gravel
and sand
brass
steel
high-grade steel
plastic
other materials on request
Full cone spray pattern
dimensions in mm
Pic. 1
Pic. 2
* Depending upon flow rate spray angle
can hand the short execution with 120°.
Ask consultation!
Plastic nozzles can exhibit other SW
Order example: (threads - type - spraying angle - material) 3 " - VI 41 - 90°- V2A
B = orifice diameter, E = closest cross section, the drillings vary with different spray angles easily
The following spray angles are available: 60°- 90°- 120°, other spray angles on request
thread
G ISO 228
Technical changes pre keep,
conditions 01 January 2007
flow rate V (l/min.) with pressure p (bar)
YAZGAN Makine ve Gida Ltd. Sti. • Kaynarca Cad. 3 • 34906 Sihli / Pendik
Istanbul – Türkiye • Tel.: 0216/3783765 • Fax: 0216/3782861 •[email protected]
chapter: 03