Hand Tools Guide - TETRIX Robotics

Additional Guides
TETRIX® Getting Started Guide
Hand-Tools Guide
Tool:
7/64" Hex Key
Used With:
Useful Information:
5/16" SHCS
• The 7/64" Hex Key can be used with
any of the Socket Head Cap Screws.
• These are the most frequently used
screws in the set, so this hex key will
be used often.
1/2" SHCS
3/32" Hex Key
Motor Shaft Hub
• The 3/32" Hex Key can be used with
both the Motor Shaft Hub and the Axle
Hub.
• These hubs are similar in appearance
but have very different uses.
Axle Hub
5/64" Hex Key
3/8” BHCS
1/16" Hex Key
Axle Set Collar
• The 1/16" Hex Key can be used with the
Axle Set Collar.
• Because the collar is very small, make
sure that it is placed where it can be
easily accessed with a hex key.
HITechnic DC Motor Controller
• The screwdriver can be used to
tighten the screws to secure the wires
in place after they are connected to
the motor controller.
4-in-1 Screwdriver
• The 5/64" Hex Key can be used with
the 3/8" Button Head Cap Screw.
• The screw itself is only 1/16" smaller
than the 5/16" SHCS, so instead of
using size, take note of the circular
head to distinguish between them.
317