id+ 4.5” techzone - Focal Point Lights

id 4.5” techzone
+
®
FLC4D | FLC4W | FLC44D | FLC44W
ALL GRID LUMINAIRES MUST BE SECURED TO STRUCTURE ABOVE.
non-emergency
FLC4D | FLC4W
emergency
key
- thermally protected, non-ic
FLC44D | FLC44W
- integral test switch
FLC4D | FLC4W
round module
cp
FLC44D | FLC44W
round downlight
conduit to
t-grid clip
(72134)
round wall wash
power off
power on
level
attention
see additional instructions
- emergency/non-emergency
FLC4D | FLC4W | FLC44D | FLC44W
square module
square downlight
square wall wash
nivo
HOUSING INSTALLATION
2
1
A
TO SET CEILING
THICKNESS SEE MODULE
INSTALLATION ON PAGE 3
5 1/8”
4.5”
5 1/8”
X2
5 1 /8 ”
4.5” x 4.5”
1/2” CONDUIT BY OTHERS
Luminaires must be installed by a qualified electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
IS0611 REV. A
2016 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com
1 of 4
3
4
CP HOUSING
6
make electrical connections
EMERGENCY - INTEGRAL TEST SWITCH
1
2
SEE BATTERY MANUFACTURER
INSTRUCTIONS
emergency maximum mounting height:
23.00’
WALL WASH: 19.00’
DOWNLIGHT:
BATTERY UNIT CONNECTOR INSIDE
CP HOUSING
3
FOR EMERGENCY INTEGRAL
TEST SWITCH INSTALLATION
SEE TRIM INSTALLATION
ON PAGE 3
DO NOT MATE CONNECTOR
UNTIL INSTALLATION
IS COMPLETE AND A.C.
POWER IS SUPPLIED
Fixtures must be installed by a qualified electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
IS0611 REV. A
2016 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com
2 of 4
DRIVER SERVICE
1
TRIM INSTALLATION
1
2
MODULE INSTALLATION
1
measure from bottom
of frame to finished
ceiling to determine
ceiling thickness
2
X2
set ceiling thickness
EMERGENCY - INTEGRAL TEST SWITCH
3
A
MAKE ELECTRICAL CONNECTION
Fixtures must be installed by a qualified electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
IS0611 REV. A
2016 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com
3 of 4
4
5
TRIM/MODULE REMOVAL
1
DO NOT PULL ON LENS
2
Contractor is responsible for adequately reinforcing walls and/or ceilings to support fixture weight. Focal Point, LLC accepts no responsibility for inadequately reinforced walls and/or
ceilings. The information contained in this drawing is the sole property of Focal Point, LLC. Any reproduction in part or whole without the written permission of Focal Point, LLC
is prohibited.
IS0611 REV. A 2016 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com
4 of 4