owner`s manual - Aquacart portable mobile water dispenser

1
SAFETY WARNINGS
1.
The AQUACART® water dispenser should always be operated
outside by an adult in areas that are well drained. Please keep
children away from the unit.
2.
Ensure that soapy water is not used and that the water is free of
debris, lint and the like and that no foreign materials are placed in the
AQUACART® water dispenser as this may damage the pump and
void the warranty.
3.
Check with your local water authority or EPA guidelines about the
safe storage of grey water and ensure that grey water is not allowed
to pool or stagnate.
4.
When not in use store the AQUACART® water dispenser in a dry
and sheltered area.
5.
The AQUACART® water dispenser uses a number of electrical
components. Ensure these components do not come into contact
with water as this may cause damage and void the warranty.
6.
When full the AQUACART® water dispenser is heavy. Do not
attempt to move a weight that you feel is too heavy. If you have filled
the AQUACART® water dispenser with too much water you can
dispense the water either via the trigger nozzle or by disconnecting
the hose and activating the pump switch.
7.
Do not pull the AQUACART® water dispenser by the hose as this
will damage the hose, the hose fittings and the pump and will void the
warranty.
8.
When the AQUACART® water dispenser is not in use ensure that
the pump switch is turned off.
9.
Do not leave the AQUACART® water dispenser unattended on
uneven or unleveled surfaces as it may roll or topple.
10.
If leaning the AQUACART® water dispenser back onto the rear
wheels ensure that you are able to support the weight.
OWNER’S MANUAL
PLEASE ENSURE YOU READ & UNDERSTAND THESE INSTRUCTIONS BEFORE
USING THE AQUACART® WATER DISPENSER
The AQUACART® Water Dispenser
Distributed by Aquacart Australia Pty Ltd
ABN 15 138 673 917
www.aquacart.com.au
2 1
6
11.
Never use abrasive cleaners to clean the AQUACART® water
dispenser.
12.
Avoid water entering the
AQUACART® water dispenser.
13.
Using a different hose, trigger or wand than that provided with the
AQUACART® water dispenser may affect the flow or pressure of
the water.
14.
Do not switch on the pump or operate the AQUACART® water
dispenser whilst charging the battery. This will damage the battery &
the pump & will void the warranty.
15.
battery
compartment
of
the
It is not recommended that the AQUACART® water dispenser be
filled with fertilizers or other types of chemicals as this may damage
the hose, the hose fittings and the pump and will void the warranty.
INTRODUCTION
The AQUACART® water dispenser does not require any special installation.
The AQUACART® water dispenser can hold 100 litres and is designed to
dispense cold, recycled water that is collected from a variety of sources such
as the shower, bath, rain tanks and the like. The AQUACART® water
dispenser is designed so it can be easily moved. A 12 volt battery is
connected to a 12 volt pump which is designed to dispense water at tap
pressure using the hose provided. A battery charger is included to re-charge
the battery. The AQUACART® water dispenser has three wheels which
assists the operator to move the unit. A high pressure washer can also be
connected to the AQUACART® water dispenser.
OPERATING THE AQUACART® WATER DISPENSER
FILLING WITH WATER
The AQUACART® water dispenser has a screw on lid on top. Unscrew the
lid and fill with water through the opening.
ACTIVATING THE PUMP
Lift the hinged lid located at the front of the AQUACART® water dispenser.
Activate the switch located on the pump. Activate the trigger nozzle attached
to the end of the hose to dispense water.
3
CONNECTING THE HOSE
Open the hinged lid at the front of AQUACART® water dispenser and locate
the pump. A standard hose fitting (included) is attached to the front of the
pump. Connect the hose to the pump by clicking the hose in place. The hose
connections may, from time to time, develop slight leaking. This is considered
normal, particularly with a spiral hose which has higher resistance and tension
than a normal hose. Some leaking may occur due to the hose being stretched
or due to environmental conditions such as hot or cold weather which may
cause the connections to expand or contract. If your hose leaks then you
should check that the connections are not cracked or split, reconnect and
tighten as required, and if leaking worsens see the ‘warranty’ section.
CHARGING THE BATTERY
Place the AQUACART® water dispenser in a dry, covered area in close
proximity to a power point outlet. Lift the hinged lid at the front of the
AQUACART® water dispenser.
Lift the battery charger from its
compartment and plug it into a 240 volt power point.
AUTOMATIC MONITORING – Your new AQUACHARGER™ battery
charger is completely automatic and may be left on whenever input power is
made available to the charger. The charger output depends on the condition
of the battery it is charging. When the battery is fully charged, the indicating
light will turn green and the charger will switch itself to a storage charge mode
and will automatically monitor and maintain the battery at full charge.
WARRANTY
Thank you for purchasing the AQUACART® water dispenser.
The
AQUACART® water dispenser is covered by a 12 month home use warranty
from the date of purchase against any manufacturing defects. In the unlikely
event that something goes wrong please return the AQUACART® water
dispenser with your receipt to the place of purchase. The warranty does not
cover the replacement of parts due to normal wear and tear, any fault caused
by incorrect installation, or any fault caused by misuse, abuse, accident or
service by other than an authorized AQUACART® water dispenser agent.
Under this express guarantee liability is limited to repair or replacement of the
product and will not include loss or damage of any kind whatsoever, whether
incidental, consequential or otherwise.
For more information on the AQUACART® water dispenser visit
www.AQUACART.com.au or contact your retailer.
4
Important Note: DO NOT leave the Sealed Lead Acid battery in a
discharged state as this can cause the battery to Sulphate if left in a discharged
condition. Always put the battery back onto charge after use.
For the full instructions on the AQUACHARGER™ battery charger please
visit our website at www.aquacart.com.au
MOVING THE AQUACART® WATER DISPENSER
The AQUACART® water dispenser has two rear wheels. A smaller wheel is
located underneath at the front and is recessed into the unit.
The front wheel allows the unit to be easily moved on level surfaces such as
concrete.
The AQUACART® water dispenser can be pulled or pushed. Which method
is easiest will depend on the operator, the amount of water in the
AQUACART® water dispenser and the type of surface. Generally, with a
heavier load it will be easier to pull the AQUACART® water dispenser.
On rougher and difficult surfaces such as grass, gravel, soil and the like, and
with a heavy load, it may be difficult to wheel. However, it is possible to lever
or lean the AQUACART® water dispenser back onto its rear wheels and
maneuver it like a wheelie bin.
Care should be taken when leaning the AQUACART® water dispenser onto
its rear wheels. At all times ensure that you are able to support the weight
before you move or lean back the AQUACART® water dispenser.
USING A HIGH PRESSURE WASHER
A high pressure washer can be attached to the AQUACART® water
dispenser. Remove the trigger nozzle from the hose and connect this end of
the hose to the high pressure washer. Connect the high pressure washer to a
240 volt outlet as per its normal operation. Lift the hinged lid on the front of
the AQUACART® water dispenser and activate the pump switch. Activate
the power switch on the high pressure washer and operate the high pressure
washer as per its normal operation.
Ensure that there is sufficient water in the AQUACART® water dispenser.
‘Dry’ running a high pressure washer may damage the pump and void the
warranty on the high pressure washer.
5