Power Units - Analog Low Res

Monode
Power UnitsAnalog
• Easy to use for hand marking
• Color coded cord receptacle
• Surface and deep etch marking
• Easy to read power selector
• AC or DC power output
9200 Tyler Boulevard • Mentor, OH 44060 • Phone: (440) 975-8802 • Fax: (440) 975-1364
Email: [email protected] • www.monode.com
M-311
Deep Etch Power Unit
• Easy to use for hand marking
• Surface marking or deep etch
• Easy to read power selector
• AC or DC power output
• A-F Low = 6, 8, 11, 14, 17 and 20 volts
• A-F High = power to 40 volts
• Color coded cord receptacle
Capable of marking more than .006 inch deep in most substrates the Monode
deep marking process is safe, legible and most importantly low stress.
M-150
Dual Purpose PowerUnit
• Easy to use for hand marking
• Surface marking or deep etch
• Easy to read power selector
• AC or DC power output
• A-F = 5,8,11,14,17 to 20 volts
• Color coded cord receptacle
Typically a general use power unit suited for most tool crib and hand marking
requirements. For shallow marks (.0001) to deep etches (.003).
M-400 CC-B
Solid State Power Unit
• Easy to use for hand marking
• On/Off cycle range from .2 to 2.4
seconds
• AC or DC power output
• A-F = 5,8,11,14,17 to 20 volts
• Color coded cord receptacle
The pulsing current generated by this unit results in deeper marks and longer
stencil life.
M-510-B
Solid State Controlled Etch
Power Unit
• Easy to use for hand marking
• Surface marking or deep etch
• On/Off cycle range from .2 to 2.4
seconds
• AC or DC power output
• A-F Low = 5,8,11,14,17 to 20 volts
• Color coded cord receptacle
Can be used as a hand marking unit or in conjunction with the AM10A
Semi-Automatic.
M-45
Dual Purpose Power Unit
• Easy to use for hand marking
• AC or DC power output
• A-C= 1.5, 3.0 to 4.5 amps
• Color coded cord receptacle
This unit is designed for small marks or occasoinal marking requiremnts.
MBG
Basic Marking Kit
First choose your power unit:
Kit includes:
Bench Fixture B2045
Stencil Cleaning Tray
Monode ElectrolyteMSC 4
and
APC Neutralizer
Holder for Hand MarkerH100
½ x 1½ Hand Marker 50150
DE Pads for Hand MarkerDE 50150
3-Wire Cort Set#300
Hand GroundHG
Shallow Etching Vs. Deep Etching
Shallow Etching
• Approximately .0001 to .001 of an inch deep
• Mark is typically produced in less than a second
• Impression is dark in color
Deep Etching
• .001 - .003 inches deep
• If etches greater than .003 inches are required a pulsating power unit with
timer is recommened