WX10605 - Westclox Big Ben Alarm Clock

SETTING THE ALARM
Turn the ALARM TIME SET knob located on the back in a clockwise
direction as indicated by the arrow on the back of the clock, until the
desired alarm time is reached.
INSTRUCTIONS
KEYWOUND ALARM CLOCK
Thank you for your purchase of this quality clock. The utmost care has
gone into the design and manufacture of your clock. Please read these
instructions carefully and store them in a safe place for future reference.
PRODUCT DESCRIPTIONS
1. HOUR hand
2. MINUTE hand
3. ALARM indicator
4. ALARM ON/OFF knob
5. ALARM TIME SET knob
6. ALARM TIME WINDING key
7. TIME WINDING key
8. TIME SET knob
9. REGULATOR lever (requires small
jeweller screwdriver to adjust)
Note: The alarm indicator on the dial will turn in a counter clockwise
direction.
TURNING THE ALARM ON/OFF
1. The ALARM ON/OFF knob is located on the back of the clock. To
turn the alarm ON, pull the ALARM ON/OFF knob away from the
case so it is in the ON position.
2. To turn the alarm OFF, push the ALARM ON/OFF knob toward the
case so it is in the OFF position.
WINDING YOUR CLOCK (TIME)
Note: Your clock does not require batteries or electricity to operate.
Turn the TIME WINDING key in a counter clockwise direction as
indicated by the arrow on the back of the clock, until the knob will not
allow you to turn it any further.
1
2
Note: The time winding key when fully wound will last approximately 36
hours, however it is recommended that the clock is wound once a day
for continuous uninterrupted time keeping.The clock should be wound
approximately the same time every day.
WINDING YOUR CLOCK (ALARM)
3
Turn the ALARM TIME WINDING key in a counter clockwise direction
as indicated by the arrow on the back of the clock, until the knob will
not allow you to turn it any further.
Note: It is recommended to wind the alarm time winding key right after
the alarm is turned off. If you do not use the clock for the alarm, there is
no need to wind the alarm time key.
REGULATING THE TIME FOR ACCURACY
Note: The clock has been regulated at the factory but due to shipping,
the clock may need to be adjusted to keep accurate time. The following
adjustment requires a small jewellers screwdriver to adjust the
REGULATOR lever located on the back of the clock.
If your clock runs fast, you can adjust the REGULATOR lever towards
the “-” symbol marked on the back of the clock.
4
5
6
7
If your clock runs slow, you can adjust the REGULATOR lever towards
the “+” symbol marked on the back of the clock.
CARE OF YOUR CLOCK
8
1. Store the clock without batteries when not in use.
9
2. A soft cloth or paper towel may be used to clean your clock.
Do not use corrosive cleanser or chemical solutions on the clock.
Keep the clock clean and dry to avoid any problems.
3. Avoid putting the clock in a highly humid environment such as
poolside or in a bathroom.
The following instructions explain how to operate your Big Ben
keywound alarm clock.
4. Do not expose the clock to direct sunlight, extreme hot or
cold temperatures.
SETTING THE TIME
Turn the TIME SET knob located on the back in a counter clockwise
direction as indicated by the arrow on the back of the clock, until the
correct time is reached.
Note: The hands on the dial will turn in a clockwise direction.
Printed in China
KEYWOUND ALARM CLOCK