bellfires - LinTronic

Transcription

bellfires - LinTronic
BELLFIRES
http://www.lintronic.dk
BELLFIRES
http://www.lintronic.dk
UPDATED: 100518
BELLFIRES
The job is to convert the BEO5's IR signals into
RF signals for the Bellfies fireplace.
We made a special firmware for the RELAY 208
in order to take care of this job.
G B A 2 1
COM2
GND 12V
C A R
C A R
6
5
C A R
7
C A R
8
http://www.lintronic.dk
1
2
3
4
C A R
C A R
C A R
C A R
COM1
123
BELLFIRES
The customer bought an extra remote, which we
opened and soldered a couple of wires in parallel
witht the poush-buttons.
Then we drilled two holes to
pass the wires through the
cabinet, and connected the
wires to the RELAY 208.
http://www.lintronic.dk
BELLFIRES
RF CONTROLLED FIREPLACE
Open the RF remote and connect/solder
the relays directly to the buttons.
This solution will work
on any kind of RF remote control
G B A 2 1
COM2
GND 12V
C A R
C A R
6
5
C A R
7
C A R
8
1
2
3
4
C A R
C A R
C A R
C A R
COM1
123
UP
OFF
http://www.lintronic.dk
DOWN
BELLFIRES
The firmware was designed to react to
4 pcs. BEO5 commands called
Function-1, Function-2, Function-3 and Function-4.
The four Function-commands will trigger:
Function-1 Off (Relay 1)
Function-2 Down (Relay 2)
Function-3 Up (Relay 3)
Function-4 On (Off and Up at the same time)
The Function-commands work in all modes TV,
Radio,etc. so the BEO5 is easy to configure.
The On-time for the relays is customer-adjustable in
the Configurator.
G B A 2 1
COM2
GND 12V
C A R
C A R
6
5
C A R
7
C A R
8
http://www.lintronic.dk
1
2
3
4
C A R
C A R
C A R
C A R
COM1
123
BELLFIRES
For this customer the firmware is recognized as: RELAY 208 - 10027
http://www.lintronic.dk