intrafuse mossberg 500 series t6 stock set

Transcription

intrafuse mossberg 500 series t6 stock set
INTRAFUSE MOSSBERG 500 SERIES
T6 STOCK SET
PACKAGE INCLUDES:
(1) MOSSBERG 500 SERIES STOCK ADAPTOR
(1) SAW STYLE PISTOL GRIP
(1) T6 STOCK BODY
(1) TAPCO BUTTPAD
(1) 6 POSITION STOCK TUBE
INCLUDED HARDWARE:
5/16” - 18 X 1 3/4” SHCS
MOSSBERG ADAPTOR SCREW
ADAPTOR SCREW
WASHER
10-32 X 1 1/4”
STOCK TUBE SCREW
1/4” X 1”
PISTOL GRIP SCREW
X2
INSTALLATION:
BEGIN BY MAKING SURE THE WEAPON IS UNLOADED
SLING NUT
10-32 STOCK TUBE NUT
X2
1. REMOVE THE OLD STOCK FROM THE SHOTGUN BY REMOVING THE BUTTPAD AND THEN REMOVING
THE STOCK SCREW.
2. LINE UP THE TAPCO STOCK ADAPTOR TO THE SHOTGUN. SCREW IN THE ADAPTOR SCREW AND WASHER.
3. INSTALL THE 6 POSITION STOCK TUBE AND T6 STOCK BODY INTO THE STOCK ADAPTOR. APPLIED PRESSURE MAY NEEDED IN ORDER TO SEAT THE
STOCK COMPLETELY INTO THE STOCK ADAPTOR.
4. SECURE THE STOCK TUBE USING THE 2 STOCK TUBE SCREWS AND THE 2 STOCK TUBE NUTS
(IF INSTALLING WITH THE SLING NUT USE IN PLACE OF ONE OF THESE NUTS).
5. INSTALL THE PISTOL GRIP BY LINING UP THE HOLE IN THE GRIP WITH THE HOLE ON THE BOTTOM SIDE OF THE STOCK ADAPTOR USING THE
PISTOL GRIP SCREW.
6. FIT THE BUTTPAD AROUND THE END OF THE STOCK BODY.
7. PERFORM A SAFTEY CHECK TO ENSURE ALL PARTS ARE TIGHTENED AND SECURE.
THIS PRODUCT IS BACKED BY A LIFETIME GUARANTEE. FOR PRODUCT SUPPORT AND UPDATES PLEASE REGISTER YOUR
PRODUCT AT WWW.TAPCO.COM/REGISTRATION