01-08 Produktinformation_EN_01-2016.indd

Transcription

Polycarbonate manholes
Special manholes
Rail trough
 Rail trough for coupling coils and switching points made by
Siemens and BBR for installation in the tram area
Page 2
Drainage box
 For rail drainage in the tram area
Page 3
Rail terminal box
 Connection of return conductor and earthing cable in the
covered and open tram/track area
Pages 4-5
Point heating box
 For application in general railway traffic
Pages 6-7
Special manholes
Rail trough for coupling coil or switching point
Area of application
 Rail trough for coupling coils and switching points made by Siemens and BBR for installation in the tram area
Technical data
 Overall height 172 mm
 > Steel frame separated, hot-dip galvanized
Rail through with installed
Siemens coupling coil/switch point
 Epoxy resin cover
- maximum load 125 kN
- Skid-proof sand-coated
 Cone bushings and lock washers
prevent in combination with an elastomer pad between cover and steel frame the automatic loosening of the bolting connection and rattling noises
 Nuts for cover fastening can be replaced from the inside later on
 Reinforcing frame made of polycarbonate (PC)
 Base plate made of polycarbonate
- With set break points for cable entry point and drainage
- With ribs for securing coupling coils/switching points
on the mounting brackets included in the delivery contents
 Spacing strip made of plastic enable optimum adjustment of coupling coils/switching
points with different heights
 Type EK 548 | EK 278 | EK 528
Fixtures
Rail through with installed BBR
coupling coil/switch point
 Mounting option for coupling coils/switching point.
Installation examples, see figures on the right side (EK 278).
Available sizes
LW 250 x 800 mm
Outer dimensions 400 x 950 mm
Weight approx. 45 kg
Type EK 548
LW 250 x 550 mm
Type EK 278
Rail through with installed
Siemens coupling coil/switch point
2
LW 250 x 400 mm
Type EK 528
Drainage box EK 362
for grooved rail | Ri 59 / Ri 60
Area of application
 For rail drainage in the tram area
Technical data
 Cast iron cover D 400 - DIN EN 124
 Drainage opening in the grooved rail
 Formwork frame
 Damping material made of cellular rubber
 Drainage pipe
 Patented damping frame made of PC
Schematic diagram
3
Special manholes
Terminal box EK 298
for grooved rail | Ri 59 / Ri 60
Area of application
 Connection of return conductor and earthing cable in the covered and open tram/track area
Technical data
 Robust waterproof box made of polycarbonate, with grey cast iron cover
 A 2 cover bolting, customer-specific bolt head
 Housing with stepped cable connection stepped grommets
 Reinforced housing edge made of A 2 in the cover area
 Housing geometry in the rail connection area adjusted to standard grooved rail Ri 60
 Different rail type adjustments (by tool change) upon request
 Contact between housing and rail established via rivet or conical bolt system, see detail X (e.g. by
Cembre)
 Degree of protection IP 56
 Environment-friendly plastic - recyclable
Dimensions
4
Terminal box EK491
for grooved rail | Ri 59 / Ri60
for Vignoles rail | 49 E 1
Area of application
 Connection of return conductor and earthing cable in the covered and open rail area
Technical data
 Robust steel housing with grey iron cast cover
 Cover bolting made of stainless steel
 Connection gland for cable entry
 Optimum handling using variable connection sets
 Further rail type adjustments upon request
Dimensions
5
Special manholes
Heating box of type EK 390
Area of application
 For application in general railway traffic.
Technical data
 Inlet gland for heating rod connection cable
 Inlet for heating rod
 Flange for welding the protective pipe for the heating rod
Point with heating box
for grooved rail Ri 60
Heating box
6
Heating rod with
protection pipe
Point blade
Stock rail heating box of type EK 392
Area of application
 For application in general railway traffic
Technical data
 Flange for welding the protective pipe for the heating rod
 Inlet for heating rod
 Inlet gland for heating rod connection cable
Point with stock rail heating box
for stock rail BA 75 (with rework)
Stock rail
Heating rod with
heating box
protection pipe
Heating rod with protection pipe
7
Kontakt | Contacts
Telefon | Phone
Internet
Langmatz GmbH
Am Gschwend 10
82467 Garmisch-Partenkirchen | Germany
Telephone +49. 88 21 920-0
Fax
+49. 88 21 920-159
E-mail [email protected]
Internet www.langmatz.de
Subject to technical modifications
| As of 01-2016
We are looking forward to a visit,
a phone call or an e-mail from you.

01-08 Produktinformation_EN_01-2016.indd

Transcription

Similar documents