Goodman Conveyor Series B Belt Idlers

Goodman Conveyor
Series B Belt Idlers
Minimum roll gap prevents damage to belts
Smooth configuration of roll end
prevents material build-up
ROII ends are precision
steel stampings which are
pressed and welded into\
machined roll shell
Dust shield provides
extra bearing protection
Goodman Conveyor
Series B Idlers meet or
exceed CEMA Series B
standards
.
I
Precision ball bearings with seal
for free turning and long life
truss type constructi
Die formed steel stands
designed for greater stiength
ntire frame fixture-welded
to assure accuate roll alignment
with fixturewelded foot plates
6138F
Features
20° or 3S0 Trough Angle
Replaceable BearingslRemovable Rolls
Goodman Conveyor Series B belt idlers are offered with either
20° or 35O trough angle. The 35O units are recommended for
high volume materials of uniform size such as wood chips,
where it is advantageous to handle a greater volume on the
same belt width.
The roll assemblies are secured at each end by a horseshoeshaped, spring steel clip which engages milled slots in the
shaft. The clips are easily removed if bearing replacement is
necessary. Rolls are secured in the frame assembly by special
clips providing a rigid, one-piece unit, yet allowing easy roll
removal when necessary.
4" and 5" Diameter Rolls
The 4" and 5" diameter rolls are of one-piece construction with
factory sealed ball bearings for permanent roll lubrication. The
rolls are fitted at either end with deep groove, high capacity,
precision ball bearings, having a flexible lip type seal and a
steel shield toward the inside of the roll.
To further protect the bearing assembly from dirt and damage,
a shield is pressed on the shaft outside the bearing.
The solid 17mm shaft provides strength and the small moment
arm minimizes shaft slope at bearing which increases bearing life.
24-BELT C O N V E Y O R I D L E R S
Rigid End and Center Stands
End and center stands are die formed from steel plate, and
end stands are channel formed for greater rigidity. Stands and
foot plates are fixture-weldedto the self-cleaning inverted base
angle, assuring accurate roll alignment.
In addition to 20° and 35O troughing idlers, a complete line
of idlers, including 5" diameter rubber disc returns, is available.
These have the same design features described above.
I
Goodman
Conveyor
Series B
STANDARD PAS&
WIM
Roll Diameter: 4 and 5"
Ball Bearings
BASE
lt2'BOLT
SIZ
VIEW X-X
LlUl
ions in inches.
in pounds.
Certified dimensions on request.
Specifications subject to change without notice.
BELT CONVEYOR IDLERS
Goodman
Conveyor
Series B
ROII Diameter: 4 and 5"
VIEW X-X
26-BELT CONVEYOR IDLERS
Ball Bearings
e
Oodman
onvevor
Series B
mensions in inches.
eight in pounds.
Roll Diameter: 4 and 5"
Ball Bearings
Certified dimensions on request.
Specifications subject to change without notice.
BELT CONVEYOR IDLERS-27