INSTALLATION INSTRUCTIONS

072704-1
Part Number: NIS-201-04
INSTALLATION INSTRUCTIONS
Always check our website for the most updated model year compatibility information.
NISSAN TITAN (2004-2007)
NISSAN ARMADA (2004-2007)
INFINITI QX56 (2004-2007)
NOTE: READ INSTRUCTIONS COMPLETELY BEFORE INSTALLING THIS BRACKETRON PHONE MOUNT.
All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever your
removing or handling plastic parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break.
Logo and part number will be right side up and readable when installed.
TOOLS NEEDED: Dash Trim Tool, (Part #SIT-104), #2 Phillips Screwdriver.
PARTS INCLUDED: Custom Bezel Mount and Instructions
LOCATION OF MOUNT: To the left of the radio.
Step 1.
Dash Trim Tool
Start by applying the parking brake then place the transmission
into nuetral. Insert the Dash Trim Tool in behind the upper right
corner of the radio/climate control trim bezel and carefully pull
back to release the top right clip of the bezel. Continue working
the remaining clips loose with the Dash Trim Tool. Note: There
are two small retainer clips on each side of the radio. These
must also be carefully released. Place the trim bezel on protective cloth to prevent damage from occuring. There is no need
to disconnect any wiring.
Step 2.
Locate and remove the four (4) Phillips screws that hold the
radio in place. Pull radio out just enough to slide the Custom
Bezel Mount behind the radio mounting bracket, surrounding
the top left screw hole and guiding pin. Place radio back into its
cavity and install the four (4) factory Phillips screws.
Guiding Pin
Original Phillips Screw
Step 3.
Carefully reinstall the dash in reverse order securing the bezel
and clips. You will hear and feel a “click” when the trim bezel
is secure. Note: There are two small retainer clips that need to
be manually pushed back to allow the trim bezel to fit back into
place.
Install any Bracketron phone holder or Amps compatible device
to your Custom Bezel Mount.
Your installation is complete.
© Bracketron Inc, 2007 All rights reserved.
The information in this document is subject to change without notice. Bracketron Inc. assumes no responsibility for any errors that may appear in this document nor do we assume any liability in
connection with its use. This supersedes and voids all previous literature. Please contact the sales department for additional information.
Bracketron Inc will not be responsible or liable for damage to vehicles in the installation and or removal of this Bracketron Inc mount.
Bracketron Inc will not be liable for personal injuries or damage to property resulting from a motor vehicle accident and or improper installation of this Bracketron Inc mount.
Bracketron Inc. 5249 West 73rd Street, Suite G, Edina, MN 55439, Ph: 952-746-7775 Fax: 1-800-660-1784 Toll Free: 1-866-237-4443
Web Address: www.bracketron.com