202_141_28222_HAND.pd

REO 2 S S1
Reo 2 S S1
Correcte verwijdering van dit product (Elektrische & elektronische afvalapparatuur)
Comment éliminer ce produit (Déchets d'équipements électriques et électroniques)
Korrekte Entsorgung dieses Produkts (Elektromüll)
Correct disposal of this product (Waste electrical & electronical equipment)
Eliminacion correcta de este producto (Material eléctrico y electronico de descarte)
Corretto smaltimento del prodotto (Rifiuti elettrici ed elettronici)
E nkel ges chikt voor toes tellen op zeer lage s panning (minder dan 50 V AC )
C onvient uniquement pour les produits à très bas s e tens ion (moins de 50 V AC )
G eeignet für G üter mit s ehr niedriger S pannung (unter 50 V AC )
Only s uited for goods at very low voltage (below 50 V AC )
S e recomieda únicamente para aquellos productos de tens ión muy baja (menos de 50 V AC )
Vale unicamente per i prodotti a tens ione molto bas s a (inferiore a 50 V AC )
Toes tel niet ges chikt om te worden afgedekt met thermis che is olatie.
Luminaire not s uitable for covering with ins ulating material.
Luminaires non appropriées pour recouvrement d'un matériau is olant thermique.
Das G erät/Die Leuchte darf nicht abgedeckt werden mit thermis cher Is olation.
Luminaria no apta para cubrir con material ais lante.
Apparecchio non adatto per es s ere coperto da materiale is olante.
57
Ins talleer het armatuur enkel in ruimten waar direct contact met water onmogelijk is .
C et êquipement doit être ins tallé dans des pièces hors de toute projection d'eau.
Dies e Leuchte darf nur in R äumen verwendet werden, in denen ein direkter kontakt mit was s er nicht möglich is t
T his fitting s hould only be ins talled in rooms where direct contact with water is impos s ible
E s te aparato s olamente puede s er ins talado en habitaciones donde el contacto directo con el agua s ea impos ible
Ques to apparecchio di illuminazione deve es s ere ins tallato s olamente in locali in cui il contatto con l'acqua è impos s ibile.
4
162
84
G elijks troomtoevoer
Alimentation DC
G S -Zufuhr
DC s upply
Alimentación de C C
Alimentazione C C
Bevestiging plafond inbouw
Montage plafond encastré
Montage decke eingebaut
Fixation ceiling recessed
Montaje techo empotrado
Montaggio soffitto incasso
Beschermd tegen vaste voorwerpen die groter zijn dan 12 mm
Protégé contre les objets solides de plus de 12 mm
Geschützt gegen Festkörper größer als 12 mm
Protected against solid objects greater than 12 mm
Protegido contra objetos sólidos superiores a 12 mm
Protetto contro oggetti solidi più grandi di 12 mm
Beschermd tegen vaste voorwerpen die groter zijn dan 1,0 mm - Beschermd tegen sproeiwater
Protégé contre les objets solides de plus de 1,0 mm - Protégé contre les pulvérisations d'eau
Geschützt gegen Festkörper größer als 1,0 mm - Geschützt gegen Sprühwasser
Protected against solid objects greater than 1,0 mm - Protected against spraying water
Protegido contra objetos sólidos superiores a 1,0 mm - Protegido contra agua pulverizada
Protetto contro oggetti solidi più grandi di 1,0 mm - protetto contro gli spruzzi d' acqua
max.22
144 x 66 x 55
CRI > 80
CRI > 90
4000K
750 lm
REFLECTOR FL-33°
REO 2 S 4033 S1
202 141 28224
= C-B / W-C / W-W
REFLECTOR WFL-50°
REO 2 S 4050 S1
202 141 28234
= C-B / W-C / W-W
3000K
660 lm
580 lm
REFLECTOR FL-33°
REO 2 S 3033 S1
202 141 28222
= C-B / W-C / W-W
REO 2 S 3033-9 S1
202 141 29222
= C-B / W-C / W-W
REFLECTOR WFL-50°
REO 2 S 3050 S1
202 141 28232
= C-B / W-C / W-W
REO 2 S 3050-9 S1
202 141 29232
= C-B / W-C / W-W
2700K
620 lm
525 lm
REFLECTOR FL-33°
REO 2 S 2733 S1
202 141 28223
= C-B / W-C / W-W
REO 2 S 2733-9 S1
202 141 29223
= C-B / W-C / W-W
REFLECTOR WFL-50°
REO 2 S 2750 S1
202 141 28233
= C-B / W-C / W-W
REO 2 S 2750-9 S1
202 141 29233
= C-B / W-C / W-W
FIXED
INCL.2 x POWERLED WHITE 7W
EXCL.LED POWER SUPPLY 350mA-DC
CURRENT CONTROLLED
IP20
20
43
20
20
OPTIONS
LED POWER SUPPLY 350mA-DC / DIM
LED POWER SUPPLY MULTI-POWER DIM
4-01
REO 2 S S1
DO NOT TOUCH OR CLEAN THE LED ARRAY!
144 x 66 x 65
max.22
!
Tc
65mm
Tc = 80°C max
66
0-22mm
- Use only SELV power supplies.
- Check the ratings of the power supply with those of the luminaire.
The maximum current rating must be taken into account.
The indicated typical voltage must not be used to select a constant voltage power supply but is indented to used
to select a constant current power supply that is able to cover that typical voltage.
- Take appropriate ESD measures. Avoid touching bare conductors.
- Leds or led luminaires that require a current controlled power supply must never be connected in parallel.
- Leds can be damaged by the contact with certain chemicals or chemical gasses.
Therefore led domes or led engines should never be cleaned with chemical substances.
B
RE
D
<1.5mm²
A
A
must not be used in the direct environment of a led luminaire.
Methyl acetate or ethyl acetate (i.e., nail polish remover)
Cyanoacrylates (i.e., “Superglue”)
Glycol ethers (including Radio Shack® Precision Electronics Cleaner - dipropylene glycol monomethyl ether)
Formaldehyde or butadiene (including Ashland PLIOBOND® adhesive)
Dymax 984-LVUF conformal coating
Loctite Sumo Glue
Gorilla Glue
Bleach, Bleach-containing cleaners, sprays
Loctite 384 adhesive
Loctite 7387 activator
Loctite 242 threadlocker
B
x3
SAVE!
A
B
i
2
1
MAX. 350mA-DC
B
A
- Leds are susceptible to switching transients. Therefore switching must be done in the primary circuit
of the power supply.
- DELTA LIGHT recommands to use the power supplies that are indicated in the Lighting Bible.
- Respect polarity
- Don’t test LED luminaires one by one on a powersupply that is switched on.
A
B
144
66
3
i
+
-
x4
+
-
+
-
+ - ... +
-
...
1 UNIT
4
3
...
>1 UNIT
5
OFF
ON
Delta Light® / www.deltalight.com / Last Update 04/12/2014