Lumen SkyLight Installation Guide

Lumen SkyLight
Installation Guide
October 2006
Lumen SkyLight Installation Guide. October 2006
1
2
Stage One
Timber packer is made to fit
dimensions of fixing lug on outer
section of rooflight.
Timber packer is constructed to
fit in accordance with fixing lug on
outer section of rooflight.
Important
3
We would like to state that due to the
nature of roofing materials and finishes,
it is impossible for Tuscan Foundry
Products Ltd to exercise complete
control over the use of our products.
The following information is a general
guide to installation in a typical warm
roof situation.
However, to ensure
the product is both suitable and fitted
correctly we strongly recommend that
professional advice and guidance is
sought from an architect, surveyor of
roofing contractor.
Tuscan Foundry Products,
Units C1-C2 Oakendene Industrial Estate,
Bolney Road, Cowfold, West Sussex, RH13 8AZ,
United Kingdom,
Freephone (UK): 0800 174093,
Telephone: 01403 860040, Fax: 0845 3450215
E-mail: [email protected]
Web: www.lumenrooflight.co.uk
Lumen SkyLight Installation Guide. October 2006
1
2
Stage Two
A timber fillet is added above and
below the position of the outer
section and a code 4 lead is
dressed onto the lower piece.
Important
3
4
We would like to state that due to the
nature of roofing materials and finishes,
it is impossible for Tuscan Foundry
Products Ltd to exercise complete
control over the use of our products.
The following information is a general
guide to installation in a typical warm
roof situation.
However, to ensure
the product is both suitable and fitted
correctly we strongly recommend that
professional advice and guidance is
sought from an architect, surveyor of
roofing contractor.
Tuscan Foundry Products,
Units C1-C2 Oakendene Industrial Estate,
Bolney Road, Cowfold, West Sussex, RH13 8AZ,
United Kingdom,
Freephone (UK): 0800 174093,
Telephone: 01403 860040, Fax: 0845 3450215
E-mail: [email protected]
Web: www.lumenrooflight.co.uk
Lumen SkyLight Installation Guide. October 2006
1
2
Stage Three
The outer section of the rooflight,
along with the fitted interior liner, is
lowered into position and the lugs
are screwed into the sides of the
timber packer.
Important
3
We would like to state that due to the
nature of roofing materials and finishes,
it is impossible for Tuscan Foundry
Products Ltd to exercise complete
control over the use of our products.
The following information is a general
guide to installation in a typical warm
roof situation.
However, to ensure
the product is both suitable and fitted
correctly we strongly recommend that
professional advice and guidance is
sought from an architect, surveyor of
roofing contractor.
Tuscan Foundry Products,
Units C1-C2 Oakendene Industrial Estate,
Bolney Road, Cowfold, West Sussex, RH13 8AZ,
United Kingdom,
Freephone (UK): 0800 174093,
Telephone: 01403 860040, Fax: 0845 3450215
E-mail: [email protected]
Web: www.lumenrooflight.co.uk
Lumen SkyLight Installation Guide. October 2006
1
2
Stage Four
Fix tile batons into position
Add lead to the head of the
rooflight.
Note: The lead shown on the sides
is to highlight the requirement for
lead to be used in these positions.
However, it is not to be applied as
one continuous strip and should
be placed between slates/tiles
as shown in the section detail. In
severe exposures it is advisable to
clip down the lead.
Important
3
We would like to state that due to the
nature of roofing materials and finishes,
it is impossible for Tuscan Foundry
Products Ltd to exercise complete
control over the use of our products.
The following information is a general
guide to installation in a typical warm
roof situation.
However, to ensure
the product is both suitable and fitted
correctly we strongly recommend that
professional advice and guidance is
sought from an architect, surveyor of
roofing contractor.
Tuscan Foundry Products,
Units C1-C2 Oakendene Industrial Estate,
Bolney Road, Cowfold, West Sussex, RH13 8AZ,
United Kingdom,
Freephone (UK): 0800 174093,
Telephone: 01403 860040, Fax: 0845 3450215
E-mail: [email protected]
Web: www.lumenrooflight.co.uk
Lumen SkyLight Installation Guide. October 2006
1
2
Stage Five
Add the slates to the roof,
overlapping the outer section by
approximately 25mm and covering
the lead from Stage Four.
Ensure the area is clean and
free from debris and then add
the opening casement by sliding
sideways onto the fixing bolts on
the top hinged section.
Try to avoid handling the glass
as this can damage the Active
coating.
Important
3
4
We would like to state that due to the
nature of roofing materials and finishes,
it is impossible for Tuscan Foundry
Products Ltd to exercise complete
control over the use of our products.
The following information is a general
guide to installation in a typical warm
roof situation.
However, to ensure
the product is both suitable and fitted
correctly we strongly recommend that
professional advice and guidance is
sought from an architect, surveyor of
roofing contractor.
Tuscan Foundry Products,
Units C1-C2 Oakendene Industrial Estate,
Bolney Road, Cowfold, West Sussex, RH13 8AZ,
United Kingdom,
Freephone (UK): 0800 174093,
Telephone: 01403 860040, Fax: 0845 3450215
E-mail: [email protected]
Web: www.lumenrooflight.co.uk
Lumen SkyLight Installation Guide. October 2006
Stage Six
Clad the internal reveals with
plasterboard so that only the timber
liner and the glazed section are
visible.
Important
We would like to state that due to the
nature of roofing materials and finishes,
it is impossible for Tuscan Foundry
Products Ltd to exercise complete
control over the use of our products.
The following information is a general
guide to installation in a typical warm
roof situation.
However, to ensure
the product is both suitable and fitted
correctly we strongly recommend that
professional advice and guidance is
sought from an architect, surveyor of
roofing contractor.
Tuscan Foundry Products,
Units C1-C2 Oakendene Industrial Estate,
Bolney Road, Cowfold, West Sussex, RH13 8AZ,
United Kingdom,
Freephone (UK): 0800 174093,
Telephone: 01403 860040, Fax: 0845 3450215
E-mail: [email protected]
Web: www.lumenrooflight.co.uk
Lumen SkyLight Installation Guide. October 2006
Double glazed Rooflight detail
for tile/ slate roof
Important
We would like to state that due to the
nature of roofing materials and finishes,
it is impossible for Tuscan Foundry
Products Ltd to exercise complete
control over the use of our products.
The following information is a general
guide to installation in a typical warm
roof situation.
However, to ensure
the product is both suitable and fitted
correctly we strongly recommend that
professional advice and guidance is
sought from an architect, surveyor of
roofing contractor.
Tuscan Foundry Products,
Units C1-C2 Oakendene Industrial Estate,
Bolney Road, Cowfold, West Sussex, RH13 8AZ,
United Kingdom,
Freephone (UK): 0800 174093,
Telephone: 01403 860040, Fax: 0845 3450215
E-mail: [email protected]
Web: www.lumenrooflight.co.uk