(Lean Construction) [email protected] [email protected] JIT

(Lean Construction)
[email protected]
[email protected]
JIT
Koskela 1992
"
-
-
"
"
"
-
5S TQM
1 Muda
2 Six Sigma
3 International Group for Lean Construction ( IGLC )
4
On-site Production
Oen-Of-A-Kind
6
Complixity
5
JIT
Bertelsen(2003)
-
Taiichi Ohno
1
Value
Value Stream
3
Flow
2
( Gil et al 2000 )
Last Planner
“ Last
Planner ”
“ Last Planner “
( RPS )
1
Pull
Perfection
3
Master Schedule
4
Reverse Phase Scheduling
2
( SWLA )
( WWP )
( PPC )
5S
(Kanban System )
1
Six-Week Lookahead
Weekly Work Plan
3
Percentage Plan Completed
4
First Run Study
5
Increased Visualization
6
Visual Workplace ( The 5S Process)
7
Harper, Ballard, Arbulu
8
Marketplace
9
‘Milk run’ vehicle collect material
10
Supplier kanban
11
Inventory management system
12
Satellite store
2
(
( Visual inspection)
“V”
“U” , “S” , “L” , “C”
:
1
2
Layout
Supply Chain Management
I
(Poka-Yoke
5S
II
(SMED)
Last Planner
(TVAL)
1 Single Minute Exchange of Die
2 Toyota Verification of Assembly Line
3
4
Cycle Time
Variability
(PCMAT)
II
I
-
1
a General Performance Model
Alarcon
3
Ashley
4
Cross-impact Analysis
5
Probabilistic inference
6
Incentive plans
2
GPM
–
"
"
"
"
PMBOK
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Alarcón, L.. (1993). "Modeling waste and performance in construction." Proc., IGLC-1, 1st
Conf. of Int. Group for Lean Construction, Espoo, Finland.
Alarcón, L., ” Lean Construction.”, Balkema Publishers, Rotterdam, The Netherlands(1997).
Arbulu, R., Ballard, G., and Harper, N. (2003). "Kanban in Construction." Proc., IGLC- 11,
11th Conf. of Int. Group for Lean Construction, Blacksburg, VA. .
Ballard, G. (2000). “The last planner system of production control.” Ph.D. thesis,
Univ.Birmingham, Birmingham, United Kingdom.
Bertelsen, S., (2003), "Construction as a complex system.", Proc., 11th Conf. of Int. Group for
Lean Construction, Blacksburg, VA. .
Banik, G. , (1999), "Construction productivity improvement." ,ASC ,Proc. ,35th AnnualConf.
April 7-10 Associated Schools of Construction. San Luis Obispo, CA. .
Saurin, T., Formoso, C., Guimarães, and Soares, A., (2002), "Safety and production: an
integrated planning and control model." , Proc., IGLC-10, 10th Conf. of Int. Group for Lean
Construction, Gramado, Brazil.
Howell, G. (1999). “What is lean construction – 1999.”. Proceedings , 7th Conference of
International Group for Lean Construction held on July 26-28, 1996, Univ. California,
Berkeley, CA. .
Howell, G., and Ballard, G. (1998), "Implementing lean construction: understanding and
action." ,Proc., IGLC-6, 6th Conf. of Int. Group for Lean Construction by C. Formoso .
Koskela, K. (1992) , "Application of the new production philosophy to construction." CIFE
Tech. Rep. No.72, Center for Integrated Facility Engineering, Stanford Univ., Stanford, CA. .
Koskela, L (1993). "Lean production in construction" Proc., IGLC-1, 1st Conf. of Int. Group for
Lean Construction, Espoo, Finland.
15. Koskela, L., Howell, G., and Dr. Tech. (2000). "Reforming project management: the role of
Lean Construction" Proc., IGLC-8, 8th Conf. of Int. Group for Lean Construction, Brighton,
Brazil.
16. Mastroianni, R., and Abdelhamid, T. (2003), "The challenge: The impetus for change to lean
project delivery." Proc., 11th Conf. of Int. Group for Lean Construction, Blacksburg, VA.
17. Ohno, T. (1988). Toyota Production System(TPS), Productivity Press, Cambridge, MA. 1-44.
18. Tan, B., Horman, M., Messner , J., and Riley, D. (2003), "Increasing the understanding of lean
priciples with advanced visualization technologies." Proc., 11th Conf. of Int. Group for Lean
Construction, Blacksburg, VA.
19. Womack, J., Jones, D., & Roos, D.. The Machine that Changed the World, New York,
Macmillan Publishing Company , 1990.
20. Solomon ,J.A. , 2004 ,” Application of the Principles of Lean Production to Construction “
M.S. thesis , Univ. Cincinati , ohio .
21. Womack, J., Jones, D., & Roos, D.. The Machine that Changed the World, New York,
Macmillan Publishing Company , 1990.