5 in 1 bounce house combo - Bounce Around Inflatables

Transcription

5 in 1 bounce house combo - Bounce Around Inflatables
PRINCESS PLAYLAND BOUNCE HOUSE
General info
15’x15’x13’
1 operator required
4 - 7 passengers max at one time (depending on age and passengers size)
Max weight per person 150lbs
Minimum height 36” maximum height 60”
1 x 1.0 hp blower
Setup
Unroll the inflatable onto a flat ground area, install at least 4 ground stakes around the
perimeter, and loosely tie the tethers to the ground stakes. Connect blower to the unit and
turn on. As the unit inflates close the zipper at the backside of inflatable. Secure the
tethers after the unit if fully inflated. Perform a final safety check around the unit prior to
letting passengers on.
Warning: Prior to setting the stakes into the ground, check for sprinkler systems, water
or electricity lines.
How to play
Enter the bounce house through the opening in the front, let the kids bounce around. At
an event with a line, we recommend 1 ½ minutes to 2 minutes play time, than that group
out – next group in.
NO FLIPPING – NO HEAD FIRST – 4 TO 7 PASSENGERS AT A TIME
Take down
Begin by disconnecting power to the blower; unzip the backside of the bounce house.
After unit is deflated, fold the unit into 4ths. Roll from the entrance to the backside with
zipper. Leaving the air tubes open helps let the air out while rolling.
Mother Nature
In the event of severe weather (lightning, 20+ mph winds, rain, etc) safely exit the
inflatable unit, disconnect power, and go indoors for your safety. Once the weather has
passed, you may continue using the inflatable after examining the unit for safety. When
the inflatable is wet, please inflate and dry off.
Warning: If the unit has become wet you must notify Bounce Around Inflatables as this
can damage the unit if it is not dried correctly. In the example that you do not notify us,
we may charge you the full amount to fix the unit.
Basics
All players should remove shoes, jewelry, and any hard or sharp items from their pockets
that could cause injury. To avoid neck and back injuries, FLIPS ARE NOT ALLOWED.
I the lessee have read and understood the rules for this inflatable. The lessee has agreed
to follow the rules that are presented by Bounce Around Inflatables, LLC.
Lessee: ___________________________________
Date: ______________________
5500 S. Wexford Ct. Sioux Falls, SD
Phone: 605-310-9529 Email: [email protected]
SET UP
The Bounce Around Inflatable may weigh over 300 lbs. Caution should be
exercised when lifting and handling the equipment. Use a dolly to move the
equipment.
Please pay attention to how it was rolled up. We ask that the inflatable comes
rolled back up the same way you received it. Thank you, Bounce Around
Inflatables, LLC.
DO NOT set up when windy and or it rains. MUST use a tarp when placing on tar or
cemented areas. No tarp necessary on grass.
Select a level area that is a safe distance from water, walls and other
obstructions.
Make certain that there are no overhead utility wires and ground obstacles
such as protruding sprinklers or underground pipes of any kind before
laying the protective tarp on the selected area.
Place the Bounce Around Inf latable in the middle of the tarp and unroll
the unit after removing the straps.
Connect either tube snugly (choose the one closest to the electricity
source) to the blower using the strap attached to the tube. Mak e sure
that all intake openings of the blower are free from any obstructions.
8.
Twist the vent (the other tube) several times, fold it over and secure
snugly with the attached strap. Close any extra zipper vents that may be
open on the inflatable for quick deflation. NOTE: Not all inflatables have
more than one tube. Only applicable if there is more than 2 air tubes.
9. Drive an anchor at least 3 feet from the inflatable to the ground at a 45 degree
angle with the head pointing away from the Inflatable unit. Secure the unit
at all times to the corresponding number of anchors. Use the straps to
attach the anchors to all the double-loops as provided in specific
areas on the base of the Inflatable unit.
Large units with high profiles (Giant S lides, etc) have additional tie
down loops that are located at higher points. Each of these additional
locations should also be attached to the anchor at a 45° angle.
10. Plug the blower into the closest properly grounded (GFCI) 110v outlet
only after you carefully read the blower manufacturer's safety
instructions. Turn the switch on and wait (approximately 2 minutes) until
the Bounce Around Inflatable is fully inflated and the equipment and all
parts have been examined for potentially unsafe conditions before letting
children in the Bounce Around Inflatable. As it inflates there may be zippers that
need to be closed. If the inflatable feels soft, a zipper or end must be closed off.
11.This unit requires continuous air pressure. Do not turn the blower off
while children are in the Bounce Around Inflatable.
DEFLATION PROCEDURES
1. Make sure there are no children inside or around the Bounce Around
Inflatable unit before you turn the switch off and unplug the blower.
2. Disconnect the air tube from the blower and untie the second air tube. Unzip
the quick release air chambers usually located beside the air tubes. Let both
air tubes lie parallel to each other so the air can escape freely
3. As the Bounce Around Inflatable deflates, arrange the columns to fall on
top of the base making sure that the deflated unit is evenly spread out.
IMPORTANT
When rolling inflatable, make sure all colored vinals are inside of roll. You should
only be able to see the bottom of inflatable once completely rolled. This will protect
inflatable during transport and keep the lessee from receiving damage fee’s
When rolling, be sure to start the roll as tight as possible, as this will create easy
mobility and easier maneuvering.
4. Standing in front of the Bounce Around unit (Entrance), fold the left side and
the right side so that they meet in the middle and then fold one side over
the other.
5. ALWAYS roll the Bounce Around unit towards the air tubes and
then tuck the air tubes into the roll. (Normally rolling it from front to back)
6. Secure the roll with each strap
tied into a slip knot.
7. Dolly the Bounce Around
unit into a dry area for storage.