Earth Jagua: Visual Instructions

Transcription

Earth Jagua: Visual Instructions
Earth Jagua ®
Visual
Instructions
page 1
1
Using a pen, push contents of Base Gel packet
toward tip.
3
Open plastic cone and
place in a cup. Squeeze
Base Gel into cone using
plastic glove, if necessary.
7
Massage contents of cone
until smooth.
4
Using dropper, fill bottle
with water to top of
sticker.
8
Using a pen may help to
mix all cone contents.
5
Shake until dissolved.
Pour contents of bottle
into plastic cone.
9
Using scissors, make 1/8˝
cut at tip of cone.
2
Using scissors, make 1/4˝
cut at tip of foil packet.
6
Squeeze air out of plastic
cone and reseal.
10
Slowly squeeze Earth
Jagua® Gel into bottle.
Occasionally tap bottle
on counter to settle gel at
bottom.
Continues on next page.
Copyright © 2011 Lakaye Studio
Earth Jagua ®
Visual
Instructions
page 2
11
Twist cap equipped with
fine tip onto applicator
bottle.
14
Place stencil face-down
onto skin.
18
Drying will take about
30–45 minutes. Be careful
not to smudge the design!
Copyright © 2011 Lakaye Studio
15
Hold in place for 20 seconds.
19
Once dry, Gel will be flat
and stick to skin. Wait
2–3 hours before removing with warm running
water.
12
Cut chosen design from
stencil transfer page.
16
Remove stencil.
20
You will see very little color when you first remove
the Gel. This is normal.
13
Use cotton ball to rub
eucalyptus oil onto skin.
17
Slowly trace stencil outline with Earth Jagua® Gel
by squeezing applicator
bottle.
21
Wait 24–48 hours for
blue-black color to develop. Enjoy!