Oceanid Tow Strap Assembly 101022

Oceanid
TM
WATER RESCUE CRAFT
RDC Tow Strap Attachment
1
Girth hitch the web loop end of the 12 inch strap through the bow end large D ring so that
the support O ring hangs about 10 inches below the girth hitch.
2
Thread the free attachment O ring onto the middle of the 78 inch strap.
3
Pass both ends of the 78 inch strap through the support O ring on the 12 inch strap.
4
Connect the ends of the 78 inch strap to the RDC large tow D rings using the ¼ inch SS
connector links.
5
Connect your line hardware to the attachment O ring that is free floating on the 78 inch
strap.
CAUTION! DO NOT CONNECT YOUR ATTACHMENT HARDWARE DIRECTLY TO THE
SUPPORT O RING OR THE TOP LARGE D RING!
This system allows the lower tow D rings to remain in shear tension, creates a change of direction
at the support O ring and suspends the attachment at or above the water surface eliminating most
potential snags.
Oceanid Inc. ♦ 1801 Chuckanut Ridge Drive ♦ Bow WA 98232 ♦ Tel 208.322.3600 ♦ [email protected] ♦ Oceanid.com