x0xb0x custom PCBs install manual

Transcription

x0xb0x custom PCBs install manual
Page 1
rev 0.5 january 28 2011
x0xi0 x0xb0x Custom PCB's - Mainboard
Diodes
1N4148
D1-D10,D24-D31,D32-D34,D36,D37
Page 2
x0xi0 x0xb0x Custom PCB's - Mainboard
Resistors
LED Resistors
10K
R203-R205,R208,R211,R213,R215,R217,R221-R223,R227-R229,R237-R239,R241-R246,R248,R249,R250-R253
R207,R254-R256,R258,R260-R262,R264-R270
R34,R36,R64,R65,R94,R96,R97,R101,R105,R109,R112,R115,R116,R142-R144,R148,R149,R157,R158,R160,R201
R202,R207,R209,R210,R212,R214,R216,R218-R220,R224-R226,R230-R233,R240,R245,R247,R254,R255,R257
R258,R263,R269,R270
Page 3
x0xi0 x0xb0x Custom PCB's - Mainboard
Resistors
100
1K
100K
1M
R95,R130,R132,R152
R137,R234,R344B
R35,R59,R66,R72,R73,R92,R93,R99,R102,R113,R114,R118,R122,R139-R141
R91,R200
Page 4
x0xi0 x0xb0x Custom PCB's - Mainboard
Resistors
22
2.2K
22K
220K
R150
R67-R71,R98,R104,R107,R108,R124-126,R162
R45,R60,R110,R111,R117,R120,R134,R146,R151
R63,R103,R106,R121,R131,R235,R236,R485,R486
Page 5
x0xi0 x0xb0x Custom PCB's - Mainboard
Resistors
4.7K
47K
33K
52.3K
R47, R135 (R47 extends the low range of filter cutoff, if not desired use stock value of 10K)
R46,R119
R159
R127
Page 6
x0xi0 x0xb0x Custom PCB's - Mainboard
Resistors
68K
200K
5.1M (10M)
1K PTC
R138
R74-R90 (should be matched for DAC accuracy, 0.1% recommended)
R271
R100A,R100B
Page 7
x0xi0 x0xb0x Custom PCB's - Mainboard
Resistors
JUMPER
JUMPER
NOT USED
J1,J2
R61 (gives no ENV MOD at lowest setting of ENV MOD control, if not desired use stock value of 10K)
R136,R156-R160,R161,R165
Page 8
x0xi0 x0xb0x Custom PCB's - Mainboard
IC's
74HC595
74HC165
74HC174
4066
AN6562
74HC126
AT25320 (25C33)
IC4-IC8
IC16-IC18
IC9
IC12
IC11
IC1
IC2
Page 9
x0xi0 x0xb0x Custom PCB's - Mainboard
Trimpots
50K
500K
TM7
TM3
Page 10
x0xi0 x0xb0x Custom PCB's - Mainboard
Capacitors
0.1uF CERAMIC
0.1uF POLYESTER
1nF POLYESTER
10nF POLYESTER
10nF POLYPROPYLENE
C103,C104,C107-C113
C25,C27,C41
C34,C100,C101
C10,C46
C33
Page 11
x0xi0 x0xb0x Custom PCB's - Mainboard
Capacitors
6.8nF POLYESTER
18nF POLYESTER
33nF POLYESTER
47nF POLYESTER
68nF POLYESTER
C47
C18
C19,C24,C26,C36
C54
C45
Page 12
x0xi0 x0xb0x Custom PCB's - Mainboard
Capacitors
220nF POLYESTER
1uF TANTALUM
3.3uF TANTALUM
10uF ELECTROLYTIC
1.0uF ELECTROLYTIC
C35
C62
C42
C16,C30-C32,C37,C40,C50,C72
C11,C13-C15,C22,C23,C29,C38,C105
Page 13
x0xi0 x0xb0x Custom PCB's - Mainboard
Capacitors
2.2uF ELECTROLYTIC
47uF ELECTROLYTIC
100uF ELECTROLYTIC
1000uF ELECTROLYTIC
100nF POLYESTSER
C51
C28,C44,C55
C48,C49,C102
C43
C20,C21 (this value extends the low frequency repsonse by one octave, if not desired use stock value of 10nF)
Page 14
x0xi0 x0xb0x Custom PCB's - Mainboard
Capacitors
NOT USED
C52,C53,C56,C58,C59
Page 15
x0xi0 x0xb0x Custom PCB's - Mainboard
Transistors
2SC536F
2SA733P
2SK30A(Y)
2SK30A(O)
2SC1583
BC547
Q11,Q13-Q20,Q23-Q25,Q29,Q30,Q32,Q35,Q37,Q40,Q41
Q8-Q10,Q27,Q31,Q36,Q38
Q39
Q28
Q12,Q21,Q26
Q5
Page 16
x0xi0 x0xb0x Custom PCB's - Mainboard
Transistors
2SC2291
2SC536F
2SA733P
NOT USED
Q22
Q3,Q4 (only if using BA6110)
Q1,Q2 (only if using BA6110)
Q33,Q34
Page 17
x0xi0 x0xb0x Custom PCB's - Mainboard
IC's
BA662
BA6110
LA4140
16MHz RESONATOR
ATMEGA162
IC15A (select one VCA for IC15)
IC15B
IC14
XTAL1 (be careful of this part once installed, it is fragile)
IC3, USE SOCKET
Page 18
x0xi0 x0xb0x Custom PCB's - Mainboard
IC's
TACT SWITCH
LED's
50KB POTENTIOMETER
50KD POTENTIOMETER
SW5-SW27
LED2-LED40 (for most 5mm round LED's the 0.32" stand-off's included with the x0xi0 kit should work well)
VR2,VR7
VR3,VR5,VR8
Page 19
x0xi0 x0xb0x Custom PCB's - Mainboard
IC's
50KB POTENTIOMETER
1MA POTENTIOMETER
BINARY ENCODER
ENCODER
LED
VR4
VR6
S3,S4
S2
LED1 (this is one of the two high-brightness 3mm red LED's in the x0xi0 kit)
Page 20
x0xi0 x0xb0x Custom PCB's - Mainboard
Change Log
Rev 0.1
Rev 0.2
Rev 0.3
Rev 0.4
Rev 0.5
Initial release
Fixed formatting for PDF, added tag for component R145 (1k)
Fixed component Q5 designation, part R235 (page 4) was mislabeled R135, added Top Side stuffing procedure
Color coding of component C20,C21 was missing
Added D25 and D32 to list for diodes, added several 10k resistors that were missing from the list.

Similar documents

1/6/09 7:56 PM f=0.51 /Users/c0nsumer/Documents/eagle/x0xb0x

1/6/09 7:56 PM f=0.51 /Users/c0nsumer/Documents/eagle/x0xb0x 1/6/09 7:56 PM f=0.51 /Users/c0nsumer/Documents/eagle/x0xb0x/mainboard.sch (Sheet: 1/1)

More information

Nad-705-Service-Manual

Nad-705-Service-Manual Shield plate Heat sink A (6 Pieces) Insulator SIL . TO-3P Top cover 6 (Taptite-S) BID4006 ZN3K (4 Pieces) Speaker A terminal PCB assembly Speaker earth plate 9 (Taptite-B) BID3008 ZN3K (8 Pieces) R...

More information