Cannondale Pull Shock Setup Guide - X

Transcription

PAGE 1 OF 2
OWNER’S MANUAL SUPPLEMENT
10/12
XFUSION PULL SHOCK SET-UP INFORMATION
About this Supplement
This supplement includes information for the proper installation
and set up of XFUSION shocks in the following Cannondale
models: Trigger 29’er Alloy, Trigger 26 Carbon, and both Jekyll
and Scarlet. In addition to this supplement, follow the owner’s
manual supplement information for your specific bike and the
XFUSION owner’s manual.
Cannondale supplements : http://www.cannondale.com/manuals/
XFUSION manuals: http://www.xfusionshox.com/
Page 1 of 4
Mounting the Shock in the Frame
Install the shock in the frame with the remote assembly facing
forward as shown. Apply Loctite 242 (blue) and tighten with a
good torque wrench. NOTICE: Incorrect shock installation can
result in serious frame damage.
Measuring Sag
Some bike models have sag indicators integrated with the frame
shock link; see your owner’s supplement. Sag can be measured
by the difference between the shock mounting bolts when rider
is on and off the bike. The recommended air pressure setting for
the different models are shown on page 2. Use a high-pressure
pump: Cannondale 1MP01/SLV.
REDBOUND DIAL
DAMPING REMOTE
NEGATIVE AIR VALVE
MAX PRESSURE:
175 PSI, 12 BAR
SHOCK MOUNTING BOLTS
8.0 Nm (71 InLbs)
Loctite 242 (Blue)
POSITIVE AIR VALVE
MAX PRESSURE:
475 PSI, 33 BAR
1MP01/SLV
FRONT OF BIKE
REMOTE CABLE
Handlebar Remote
The handlebar remote changes the shock performance between “OPEN” and “FIRM.” See the illustrations below.
Press the small top button to release the lever. When the
remote lever is UP, the shock is OPEN.
Press the remote lever down until it locks to change
the shock to FIRM.
129338 XFUSION PULL SHOCK SET-UP INFORMATION - 10/12
PAGE 2 OF 2
TRIGGER 29’ER ALLOY
TRIGGER 26 CARBON
RECOMMENDED SAG: 25% (32mm)
Use the table below to set intial air pressure(s) according to
rider weight; measure sag, then add or release air pressure in
small amounts to set sag.
XFUSION SHOCK INFO:
XFUSION SHOCK INFO:
CANNONDALE P/N
TRAVEL
EYE-TO-EYE
BUSHING WIDTH
CANNONDALE P/N
TRAVEL
EYE-TO-EYE
BUSHING WIDTH
128870
130mm
155 x 50mm
22 mm
128410
120mm
145 x 40mm
15.75mm
RECOMMENDED AIR PRESSURE:
RIDER WEIGHT
(LBS)
Under 100
100 - 109
110 - 119
120 - 129
130 - 139
140 - 149
150 - 159
160 - 169
170 - 179
180 - 189
190 - 199
200 - 209
210 - 219
220 - 229
230 - 239
240 - 249
POSITIVE
(PSI)
158
169
179
191
203
216
230
244
260
273
287
301
316
332
348
366
NEGATIVE
(PSI)
61
65
69
73
78
83
88
94
100
105
110
116
122
128
134
141
POSITIVE
(BAR)
11.0
11.6
12.4
13.2
14.0
14.9
15.8
16.9
17.9
18.8
19.8
20.8
21.8
22.9
24.0
25.2
NEGATIVE
(BAR)
4.0
4.5
4.8
5.1
5.4
5.7
6.1
6.5
6.9
7.2
7.6
8.0
8.4
8.8
9.2
9.7
JEKYLL / SCARLETT
RIDER WEIGHT
(LBS)
Under 100
100 - 109
110 - 119
120 - 129
130 - 139
140 - 149
150 - 159
160 - 169
170 - 179
180 - 189
190 - 199
200 - 209
210 - 219
220 - 229
230 - 239
240 - 249
POSITIVE
(PSI)
183
195
207
220
234
249
265
282
300
315
331
347
365
383
402
422
NEGATIVE
(PSI)
56
60
63
68
72
76
81
86
92
97
101
107
112
117
123
129
POSITIVE
(BAR)
12.6
13.4
14.3
15.2
16.2
17.2
18.3
19.4
20.7
21.7
22.8
24.0
25.1
26.4
27.7
29.1
NEGATIVE
(BAR)
3.9
4.1
4.4
4.7
5.0
5.3
5.6
6.0
6.3
6.7
7.0
7.3
7.7
8.1
8.5
8.9
POSITIVE
(BAR)
12.6
13.4
14.3
15.2
16.2
17.2
18.3
19.4
20.7
21.7
22.8
24.0
25.1
26.4
27.7
29.1
NEGATIVE
(BAR)
3.7
3.9
4.1
4.4
4.7
5.0
5.3
5.6
6.0
6.3
6.6
6.9
7.3
7.7
8.0
8.4
XFUSION SHOCK INFO:
CANNONDALE P/N
TRAVEL
EYE-TO-EYE
BUSHING WIDTH
128761
150mm
155 x 50mm
15.75mm
RIDER WEIGHT
(LBS)
Under 100
100 - 109
110 - 119
120 - 129
130 - 139
140 - 149
150 - 159
160 - 169
170 - 179
180 - 189
190 - 199
200 - 209
210 - 219
220 - 229
230 - 239
240 - 249
POSITIVE
(PSI)
183
195
207
220
234
249
265
282
300
315
331
347
365
383
402
422
NEGATIVE
(PSI)
53
56
60
64
68
72
77
82
87
91
96
101
106
111
117
122
129338 XFUSION PULL SHOCK SET-UP INFORMATION - 10/12

Cannondale Pull Shock Setup Guide - X

Transcription

Similar documents

FRAME PLATFORMS KITS