AS350/AS355 Series

SETTING THE STANDARD OF CUSTOMER SERVICE
AS350/AS355 Series
Tip-to-Tail Support Capabilities
Why Choose Vector Aerospace for your AS350/AS355 Series MRO
Support?
Models Supported:
AS350, AS355, EC130, EC135, BK117, EC145
Vector Aerospace Helicopter Services – North America has over 30 technicians trained by Airbus Helicopters to perform tip-to-tail
MRO services on AS350/AS355 series aircraft. With certification to perform major and scheduled inspections, D Level structural
overhaul, extensive component, airframe and avionics MRO and AS350BA to AS350B2 conversions; we are your AS350/AS355
Series one-stop-shop.
To cover your AS350/AS355 Series engine requirements, Vector Aerospace is an authorized Turbomeca Arriel 1 and Arriel 2 Repair and
Overhaul Center and an Approved Maintenance Repair and Overhaul Center (AMROC) for Rolls-Royce M250®, with over 30 years of
MRO experience on these engine platforms.
Structural Repair
●
●
●
●
●
●
●
●
●
Fuselage and tailboom fixtures - Airbus Helicopters approved
Exchange fuselage and tailboom available
Horizontal stabilizer repairs
Door and cowling repairs
Firewall repairs
Vertical stabilizer and lower fin repairs/modifications
Canopy repairs
Ultrasonic inspection equipment
Honeycomb and composite panel rebuild using the following equipment:
- Hot bond controllers and specialized heat blankets
- Cure ovens
- Vacuum clamp and bag systems
Avionics and Airframe Rewire
●
●
●
●
●
●
●
●
●
●
●
Full and partial airframe rewire
Wire harness fabrication
Laser-marked wires
Avionic package design and upgrade, including “glass cockpit” installation
Comprehensive special operations STCs
Distributor for all major OEMs
Mission equipment installation
Factory trained technicians
Line replacement unit repairs
Rental/loaner pool available
Warranty service center for major avionic OEMs
Aircraft Maintenance
●
●
●
●
●
●
●
Major and scheduled inspections
Field service
Component replacement
Project management
Pre-purchase inspections and insurance appraisals
Accident damage quotations
Component/engine repair and overhaul
SETTING THE STANDARD OF CUSTOMER SERVICE
Image Courtesy: Airbus Helicopters
BA to B2 Conversions
Aircraft Modification Highlights:
● New Turbomeca Arriel 1D1 with new manufacturer warranty
● Increased aircraft gross weight (330 lb)
● Fuel system upgrades
● Tailboom structural improvements
● Upgraded instrumentation
● Main rotor head upgrades
● Power train improvements
* Note that aircraft manufactured before 1987 will require additional aircraft specific modifications.
BA to B2 Conversion Benefits:
● Increased gross weight and hot & high performance
● Improved power margins for increased safety
● Reduced pilot workload and enhanced pilot ability
● Enhanced mission profile for better marketability
● Greater resale value offsets modification cost
● BA to B2 conversions offered worldwide
Dynamic Component Overhaul
●
●
●
●
●
●
Epicyclic
Bevel reduction gearbox
Tail rotor gearbox
Driveshaft
Complete in-house test cell
Lease and exchange units available
Arriel 1 and Arriel 2 MRO
Models Supported: Arriel 1A / A1 / A2 / B / C / C1 / C2 / D / D1 / S / S1 / E2
Arriel 2S2 & Arriel 2B / B1 /C / S1
● Engine and module Repair and Overhaul (R&O)
● Borescope inspection
● Failure analysis
● Freewheel shaft R&O
● Service Bulletin (S/B) compliance
● Model conversions
● Complete test capabilities
● Rental pool available
● Parts support
● Engineering support
● Complete service centre capabilities
● Field service
Rolls-Royce M250 MRO
Models supported: M250 Series II, III & IV turboshafts, M250 Series II turboprop
●
●
●
●
●
●
●
●
●
●
●
●
Engine and module Repair and Overhaul (R&O)
Borescope inspection
Failure analysis
Component repair
Service Bulletin (S/B) compliance
Foreign Object Damage (FOD) repair
Model conversions
Complete test capabilities
Rental pool available
Parts support
Engineering support
Field service
Image Courtesy: Airbus Helicopters
Vector HS-NA is an Airbus Helicopters
D Level Repair Center.
SETTING THE STANDARD OF CUSTOMER SERVICE
Helicopter Services – Langley, BC
Airframes | Structures | Avionics | Maintenance
#101B – 5947 206A Street, Langley
British Columbia, Canada V3A 8M1
Tel: 604.514.0388 | Fax: 604.514.0389
email: [email protected]
October 2015
Helicopter Services – Richmond
Engines | Dynamic Components | Accessories
4551 Agar Drive, Richmond
British Columbia, Canada V7B 1A4
Tel: 604.276.7600 | Fax: 604.276.7675
email: [email protected]
www.vectoraerospace.com